Ignition Switch wiring - Need Help!

[Timmer71]

Hello all, I just bought a used Kymco Super 9 LC. It is in pretty rough shape and the wiring has been hacked up. I have the key and the ignition is still in place but the wires have been pulled out and I dont know what to solder where. Does anyone have a picture of the back of there ignition where I can see what wire is soldered to where? Here is a pic of what I have (hopefully this works)


By timmer_71 at 2011-08-01

[JENNY]

I CAN GET THE WIRING DIAGRAM IF YOU WOULD LIKE TOMORROW

JENNY

[Timmer71]

Thanks, but I'm not sure that would help me figure out exactly where I'm supposed to solder each wire on to the back of the ignition. I have a copy of the shop manual but it doesn't show me exactly what I need.

[thebatman]

If you still need that, i can help with that

[Timmer71]

Well, I finally figured it out. Here is a pic in case someone else out there is in the same boat I was. I'm not 100% sure this is factory correct but it works. When the ignition is in the "on" position the black and red are connected. When the key is in the "off" position the Blue/yellow (pulsar coil) and greens (ground) are connected.


By timmer_71 at 2011-08-10

[thebatman]

Glad you got it... I'd have to look at mine to be certain of the order.... congrats

[people]

Thanks for the photograph. That is the same situation I have with my People 150. I followed your notes and the bike just started up!

[alexisdawgggg]

Hey Im in the same situation can somone please help!!!!!!!