KymcoForum.com

Scooters - 50cc => Super 9 => Topic started by: Ice-Tray on May 07, 2014, 03:24:18 PM

Title: Bleed oilpump Super 9
Post by: Ice-Tray on May 07, 2014, 03:24:18 PM

Now I finally got the oil pump and installed it today. But wondering if I bleed the system properly.
Followed the service manual from Kymco.

I fill the oil pump with oil, place on the main hose and start the moped.
It drips out the other side. Should it just drip or shall it flow a lot?

Title: Re: Bleed oilpump Super 9
Post by: 245luigi on May 07, 2014, 05:35:00 PM

Driiiiiiiiiiiiiiiip

Title: Re: Bleed oilpump Super 9
Post by: Ice-Tray on May 07, 2014, 06:30:31 PM

OK, then its all good then.

Title: Re: Bleed oilpump Super 9
Post by: Ice-Tray on June 25, 2014, 01:17:34 PM

I'm not sure if the oil pump is properly in order.
When I bled the system so drypte the oil.
But when I'm driving now so decreases almost no oil at all.

How much oil is there it should use normal?

Title: Re: Bleed oilpump Super 9
Post by: 245luigi on June 25, 2014, 01:42:28 PM

It takes me forever to use the oil in the tank, id say probably 10 or so tanks of fuel before the light comes on.

Title: Re: Bleed oilpump Super 9
Post by: zombie on June 25, 2014, 05:12:16 PM

Think about each stroke of the piston... It uses a MIST of fuel per. That mist will contain between 100:1 or 50:1 fuel/oil ratio.

Title: Re: Bleed oilpump Super 9
Post by: BettinANDlosing on June 26, 2014, 02:41:21 AM

Slow drop drop drop out of the hose when run at speed.

Title: Re: Bleed oilpump Super 9
Post by: Ice-Tray on June 28, 2014, 08:15:09 AM

Ok, tnx

Title: Re: Bleed oilpump Super 9
Post by: zombie on June 28, 2014, 08:23:23 AM

I just caught the user name. LOL LOL LOL