KymcoForum.com

Scooters - 50cc => Super 9 => Topic started by: mroc on February 21, 2015, 01:34:33 AM

Title: propeller removal
Post by: mroc on February 21, 2015, 01:34:33 AM

Doing the water seals on my s9, how.do you remove propeller bolt easily?

Title: Re: propeller removal
Post by: BettinANDlosing on February 21, 2015, 01:45:49 AM

It's an IMPELLER haha, you should use an impact to get it off.

Title: Re: propeller removal
Post by: mroc on February 21, 2015, 01:48:08 AM

K thanks. Sorry typo.

Title: Re: propeller removal
Post by: BettinANDlosing on February 21, 2015, 01:49:59 AM

No problem hahaha it looks like a propeller. You can get cheap-o impacts at Harbor Freight or stores that sell Chinese tools.

Title: Re: propeller removal
Post by: zombie on February 21, 2015, 02:21:28 AM

Correct me if I'm wrong but is'nt that a reverse thread?

Josh (Scooter Invasion) has a thread on rebuilding that set up. It's about 5 years old but complete.

Title: Re: propeller removal
Post by: BettinANDlosing on February 21, 2015, 08:00:21 AM

I don't know on the s9. Now that you say that, i think the 250 is right hand threads.

Title: Re: propeller removal
Post by: mroc on March 04, 2015, 04:38:23 AM

Yes it was reverse thread. Any idea how to get the bolt behind it out the one that runs thru the bearing seals

Title: Re: propeller removal
Post by: zombie on March 05, 2015, 05:12:53 PM

I think it is all in this thread...

http://www.scooterinvasion.net/forum/viewtopic.php?t=813&highlight=water+pump (http://www.scooterinvasion.net/forum/viewtopic.php?t=813&highlight=water+pump)