KymcoForum.com

General => Technical | How To => Topic started by: CROSSBOLT on October 13, 2023, 01:29:45 AM

Title: Threads
Post by: CROSSBOLT on October 13, 2023, 01:29:45 AM
https://www.facebook.com/reel/231080619945768?s=yWDuG2&fs=e&mibextid=Nif5oz
Title: Re: Threads
Post by: Neil955i on October 13, 2023, 06:50:06 AM
Where there’s a will…
Title: Re: Threads
Post by: Iahawk on October 13, 2023, 01:36:55 PM
Easy...right?  ::)
Title: Re: Threads
Post by: monkeybongos on October 14, 2023, 11:25:13 AM
What is the gadget used to create the threads?
Title: Re: Threads
Post by: Ruffus on October 14, 2023, 01:36:19 PM
@MB: in this case I would say 12x1.25 mm.
Title: Re: Threads
Post by: Neil955i on October 14, 2023, 06:03:47 PM
Quote from: monkeybongos on October 14, 2023, 11:25:13 AM
What is the gadget used to create the threads?

Called a tapper I believe?
Title: Re: Threads
Post by: Stig / Major Tom on October 14, 2023, 10:14:49 PM
Quote from: Neil955i on October 14, 2023, 06:03:47 PM
Called a tapper I believe?
I don't have FB...so thought this was about a new scooter "thread".

Stig
Title: Re: Threads
Post by: CROSSBOLT on October 15, 2023, 03:27:57 AM
A "die" makes external threads.

The fix for stripped threads on the crank shaft extension (which mounts the front pulley vario) was building up with weld, running engine to file the end to right O.D. then threading with a die.
Title: Re: Threads
Post by: Neil955i on October 15, 2023, 09:17:35 AM
Quote from: CROSSBOLT on October 15, 2023, 03:27:57 AM
A "die" makes external threads.

The fix for stripped threads on the crank shaft extension (which mounts the front pulley vario) was building up with weld, running engine to file the end to right O.D. then threading with a die.

You’re right of course Karl, how did I forget that?!
Title: Re: Threads
Post by: CROSSBOLT on October 15, 2023, 11:59:47 AM
Quote from: Neil955i on October 15, 2023, 09:17:35 AM
You’re right of course Karl, how did I forget that?!
Forget what?

Har, har!
Title: Re: Threads
Post by: Neil955i on October 15, 2023, 06:30:22 PM
🤣 😂 🤣