KymcoForum.com
General => General Discussion => Topic started by: superscoot on June 23, 2012, 11:47:52 PM
-
dunno if im correct but i may have a flat spot on take off as soon as i open the throttle up she creeps forward then takes off like a rocket any idears?
-
dunno if im correct but i may have a flat spot on take off as soon as i open the throttle up she creeps forward then takes off like a rocket any idears?
Sound like a cvt issue. Check the rollers are not worn, the belt is within its tollerance width, the clutch pads condition - they may just need sanding with some paper if theyre glazed or dirty, also lightly sand inside the clutch bell where the pads rub, check clutch fly springs are ok and give it general clean out with a dry paintbrush or some cleaner spray.
If that doesnt work then check the throttle cable moves with the grip by looking at it at the carb as your twist the throttle on the stand. Could be its worn or sticking.
-
thanks for the reply i do have a new belt ive yet to put it in ( got to get a inpact wrench ) so i have a look as soon as i can thanks
-
You can always open up the cover and give it a clean out, either with a spray cleaner or even just a paintbrush and without dismantling the whole thing, might help short term till you can get an impact wrench, if it is just dust and dirt.
-
i got the cvt cover off yeah its abit dirty/dusty the belt has also seen better days....just aswell i have a replacement should be getting that inpact wrench within then next couple of days....( works fault ) did get paid :( the rollers are also fine got a little trick to get the variator off with the use of a small spanner :) but the clutch is a whole diffrent story lol.....ill also give the cvt a good going over when it stops raining... thanks again for your help :)
-
No probs, just hope it works :)