Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - turnip4545

Pages: [1]
1
Agility 50 / Re: Derestrict Agility 4 stroke 50i (2020 injection model)
« on: August 23, 2022, 07:28:15 PM »
Today I fitted a kit off fleabay which included a new variator with weights and boss. This has improved acceleration.

But the original boss did not have the 'shoulder' restriction part, so the boss in the kit and original were the same.

This leads me to believe there is something else limited the top end speed, maybe just the CDi/ecu part?

My local dealer is trying to find out more information.

2
Agility 50 / Re: Derestrict Agility 4 stroke 50i (2020 injection model)
« on: July 31, 2022, 09:48:42 PM »
Quote from: Stig / Major Tom on July 30, 2022, 07:28:49 PM
Yeah....don't try messing with the idle speed!
If it is a very low mileage scoot it might run at idle better when you get some miles on it.
You could try an Iridium spark plug, which often boosts the idle speed a little....and many play around with different weight rollers looking for better acceleration and improved top speed. But, it is a 50 so- it'll never be a racer :)
I think the newer models are leaned out a bit to meet pollution restrictions - especially at start up - which can lead to less than strong idle..but nothing to worry about.
Can your dealer's service desk offer any suggestions for mods that are proven to make a difference with your model?

Welcome to the forum.
Stig

Thanks for your reply.

The bike had only done 500 miles when we purchased it from somebody else here in the UK. There is nothing wrong with it and realise it is no racer, but even 5-10mph gain would be good.

I will leave the idle as is for now and hope it runs in a bit better. There doesn't seem to be any threads online relating to the injection model either.

We will contact a local dealer as suggested and see what they come back with  ;)

3
Agility 50 / Derestrict Agility 4 stroke 50i (2020 injection model)
« on: July 30, 2022, 06:16:31 PM »
Anyone know if replacement boss and changing roller weights still possible with this newer injection model.

Also may kits show CDI and larger jet for carb, but obviously this hasn't got a carb!

Final question is when I start the bike, it sometimes needs a bit of throttle and occasionally dies, like idle speed a bit too low.

Thanks in advance  :D

Pages: [1]