1
Agility 125 / Re: Mirrors
« on: October 16, 2013, 09:53:12 AM »
Bought the 25$ mirrors posted above for mine. Had them within 3 days from order. They do the job and now i can see whats going on behind me.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Technical | How To / Re: 2010 Agility 125 RS Headlights
« on: August 10, 2013, 05:28:41 AM »
All sorted.
Lower of the two globes wasn't connected.
Also jumped the white wire to the upper globe white wire so now i have both globes operating as low beam and a high beam.
Both globes are H4 35/35
Hope this assists anyone out there.
Regards
Lower of the two globes wasn't connected.
Also jumped the white wire to the upper globe white wire so now i have both globes operating as low beam and a high beam.
Both globes are H4 35/35
Hope this assists anyone out there.
Regards
3
Technical | How To / 2010 Agility 125 RS Headlights
« on: August 08, 2013, 08:25:19 AM »
Hi all new here just purchased a new 2010 Agility 125 RS.
Great bike loving it.
Its an Aus spec build don't know if there different in other parts of the world.
My question is in relation to the headlights.
I notice in the lens there are two large bulbs.
When flicking the switch to normal low beam all is well.
If I hit the switch for high beam the the light flicks on then off.
Under load it comes on from what I can see.
There is a similar bulb underneath in the lower part of the lens this does not light up at all.
It looks to be ok looking through the lens.
Any thoughts on this or is there a special technique to get it to light up?
I checked the manual but its not all that clear and there is no mention of this extra bulb in the housing.
Any assistance would be greatly appreciated.
Great bike loving it.
Its an Aus spec build don't know if there different in other parts of the world.
My question is in relation to the headlights.
I notice in the lens there are two large bulbs.
When flicking the switch to normal low beam all is well.
If I hit the switch for high beam the the light flicks on then off.
Under load it comes on from what I can see.
There is a similar bulb underneath in the lower part of the lens this does not light up at all.
It looks to be ok looking through the lens.
Any thoughts on this or is there a special technique to get it to light up?
I checked the manual but its not all that clear and there is no mention of this extra bulb in the housing.
Any assistance would be greatly appreciated.
Pages: [1]