KymcoForum.com

Just installed HJC-2002 alarm. Not working! please help.
http://www.mwsbike.com/alarm

here's the manual
http://www.mwsbike.com/info/hjc2002.pdf

Connected the following:
Yellow wires to turn signals, one to right, one to left, no problem here.
Red wire to positive terminal of battery, and black wire to negative terminal, no problem here.
Blue wires to the black-and-yellow wire between CDI and ignition coil; I also think I did this right, by cutting the black-and-yellow wire first and attaching one end to one blue wire, and the other end to the other blue wire.

I pressed the 2nd button on the remote for 3 sec and heard a beep, indicating wireless connection being setup between the remote and the alarm. All good here.

The 2nd button (vehicle locator button) works just fine. When I push on it, all four turn signal lights (front and back) will blink simultaneously until I press the same button again. This function (vehicle locator) works perfectly.

However, the most important function (the alarm itself), didn't work. I press the 1st button, and no response from the scooter. Tried again, still no response. Checked the fuses, none blown. Started the scooter, runs well as before.

Anyway, anyone has this system? Please help. Is there something I did wrong? At least the scooter still runs...

Hi all, I am a proud new owner of a new 2009 Kymco People S 200! While I am still learning to be a good rider, I noted that the speedometer is both erroneous and very difficult to read. After much thinking, I have decided that it might be a good idea to mount my Garmin Nuvi 760 GPS onto the People S 200 and use the GPS speedometer. Has anyone tried RAM mount for such set up? If so, could someone post the model numbers? Each part of the RAM connector system has a separate model number, and I think there will be at least 4 separate modules needed for this setup (GPS holder -- ball plate -- arm -- main connector).

My thanks in advance.
and I also look forward to be a helpful member of this community.