1
Xciting 500 / Dr Pulley Clutch & Spring Weights
« on: February 17, 2011, 12:51:33 PM »
Finally i could install my HIT to mu bike. But i'm not satisfied at all. When i mail to unionmaterial i realised that there was a mistake at installation. I shouldn't have put the part into pulley clutch which was in the original clutch. They told me to install with only with pulley washer and torque spring washer. I am expecting faster take offs but not much increase in gas consumption. Top speed is not very important for me, 150 km/h is enough. What are the weight do you offer for clutch and pulley springs ? (By the way i will add some photos later)
Thanks.
Thanks.