Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - soldout

Pages: [1]
1
Agility 125 / Getting my agilty 125 to run again
« on: April 22, 2018, 01:18:12 AM »
My scooter sat for about 1 year and I went to start it last week and could actually get it to run but it wouldn't idle.  I took the carburator out and cleaned out both jets.  The idle jet was clogged and I was able to get it unclogged with tiny sewing needle andetal wire.  I got everything back together and rode around my block a few times.  I came back home and checked everything over once more and wanted to venture out of the neighborhood.  I was about 1 mile from home pulling out onto a main road and the scooter just shut off.  I've taken the carburator out again and and checked both jets.  The carburator is getting gas and have replaced the spark plugs wire because mine was loose.  If anyone can give me somethings to look for or check please let me know.  Thank you.

2
Agility 125 / Engine shuts off
« on: August 29, 2013, 04:22:55 AM »
This has happened twice now stranding me both times and having to push the bike home.  During the push home it will start and run for maybe 15 - 20 seconds then shut off again.  It sat over night and started right up again.   I took it out around the neighborhood and after about 2 minutes it shut off again.  I have the seat and bucket out right now.  I pulled the line off the filter and tried starting it, gas shot out so I know its getting fuel.  I have the guides to troubleshot but i wanted to reach out here first and see if anyone can help out.

3
Agility 125 / leaky gas tank
« on: May 18, 2013, 06:26:13 PM »
Had my agility for 3 months and put about 2000kms.  The other day I pull into the garage after work.   Then later in the evening I noticed a Gas smell coming from the garage.  A tiny pool of gas laying on the ground.   Tore the scooter apart to find the short pipe with the valve was leaking.  Not the valve but the joint between the tank and the pipe.  Anyways this doesn't leave me with the best of feeling.   I might trade/sell later or for something a little more reliable.   Anyone ever have the same problem?

4
Agility 125 / Adding heated seat and hand grips
« on: April 18, 2013, 06:24:09 AM »
I want to add heated seat and hand grips to my Agility 125.

My question is can the stock electrical system handle the additional load from heated seat and hand grips?

What if I change some of my lighting to LED bulbs will that help?

Thanks!

This is the seat specs.

Application
Carbon fiber can be trimmed to fit

Specification
Power Supply: DC 12V
Current: 5A
Measure: 40cm x 21cm (8"x15.5")
Weight: 0.7Kg
Temperature:
Range: 30°C-75°C
Indicator light RED= ON


Specs for the heated hand grips just say 10/24watts.

5
Agility 125 / Rubber O ring under seat
« on: April 16, 2013, 06:52:39 AM »
Theres a rubber o ring Kymco put this there for a reason and I cant figure out what its for other then to hold a tiny pouch of tools or something long skinny and doesnt weigh much.

Does anyone know what its purpose is?

6
Agility 125 / 12v outlet
« on: March 21, 2013, 11:59:51 PM »
I wanted to know if anyone has installed a 12v outlet to their agility and where did you install it.  If you could also post a picture that would be great.  Thanks.

7
Agility 125 / Mirrors
« on: February 28, 2013, 04:05:58 AM »
I cant stand the factory mirrors on the Agility.  I feel like Kymco really cut the corner with these.  Yeah its a mirror thats round and its mounted on an adjustable post but they just dont really work for me.  Ive only had this scooter for a few days and the first minute of riding I knew I didnt like the mirrors.  I feel like I have them adjust as best I can but if I just glance over to see behind me all I can see is my shoulder.  I have to curve my back side ways and tilt my head the other way and evem then I really cant see much behind me.  I dont feel very safe riding it.  Has anyone replaced their mirrors or added something to them to help this problem?

Pages: [1]