Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Eherim

Pages: 1 2 [3]
31
Agility 50 / Re: Gearing problem
« on: September 19, 2013, 02:59:15 PM »
I have almost no idea of what you are talking about.
I've got a feeling of what you are saying, but most of it is like russian to me. :-)

Anyway, I got the thing open and took a few pix. I would have loved to have it run while open, but for some reason (one you propably mensioned in your post) it wouldn't start up while open. So, I don't know how things look when the revolutions go up and down.

After having taken the pictures, I assembled it and it started just fine again. At first it seemed like it ran a bit better better with better acceleration at low speeds, but went back to very bad as described in my first post after a short run.

Here's the pictures:











I hope you can make something of it.
I really appreciate your help and have already at this point learned a great deal about all this, so thank you very much.

32
Agility 50 / Re: Gearing problem
« on: September 19, 2013, 09:26:54 AM »
Manual says:

"Loosen the drive belt air tube band screw.
Remove the eight left crankcase cover bolts
and left crankcase cover."

I have NO idea, what "the drive belt air tube band screw" is, and I am stuck at this point:



Lots of unscrewed bolts and a crank cover still stuck in the highlighted area of the picture.
I am not over exited about using a lot of brutal force.

I told you, I was a newbie. :-)
Any ideas?

33
Agility 50 / Re: Gearing problem
« on: September 18, 2013, 10:13:06 PM »
Thanks for the very enlightening reply. I will post an image first thing tomorrow.

34
Agility 50 / Gearing problem
« on: September 18, 2013, 09:00:38 AM »
Hi all.

I am new here, got my Agility 50 - a 2005 model - a few moths ago. So I am quite new to this scooter thing, and don't know a lot about engines and stuff. So please explain this to me as if i am a newbie, because that's what I am.  ;D

Since I got it, it has gotten new rollers, an unrestricted smooth boss and a new cdi-box with no restrictions. Now it runs 43 mi/h downhill. Other than that it used to run perfectly.
___

ANYHOW - Yesterday after a long ride, something went wrong with the gearing. Now it runs like it doesn't shift gears. The engine runs at very low revolutions at slow speeds, but normally at high speeds. This causes it to accelerate very slowly.

What could have caused this problem, and how is it fixed?

Thanks a lot in advance.

Pages: 1 2 [3]