Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - fest

Pages: [1] 2 3
1
People GT 300i / Re: Bearings kit
« on: June 13, 2023, 10:58:09 PM »
After technical difficulties, I am finally able to update the post.
I've managed to replace the bearings in my steering column. Not an easy job for sure. But the bike feels very different now.
https://ibb.co/YyqvW1t
https://ibb.co/vZyksNP

I also got Steering Stem Bearing Race Removal Tool for Yamaha TRX850 1996-2000, and made the job super easy.
https://ibb.co/Wc90FdT

I highly recommend that you check the bearings, during winter when you are not riding. As there is a lot to remove. You will also need a tool to remove the handlebar too. Cyclepedia manual will come in handy too.

2
People GT 300i / Re: Bearings kit
« on: November 30, 2022, 11:12:15 PM »
Thanks for your reply. Will let you know once i get them if they fit. I got them from another ebay seller but look similar like in that above link.

3
People GT 300i / Bearings kit
« on: November 23, 2022, 07:53:43 PM »
Hi,

Would anyone know if these bearings would fit my kymco people 300gti 2014. As they look different to stock ones.
https://www.ebay.com.au/itm/284787694126?_trkparms=amclksrc%3DITM%26aid%3D1110013%26algo%3DHOMESPLICE.SIMRXI%26ao%3D1%26asc%3D20201210111452%26meid%3D9b063add50694dfdbe3d6fdd979f742e%26pid%3D101196%26rk%3D2%26rkt%3D12%26sd%3D134285190249%26itm%3D284787694126%26pmt%3D1%26noa%3D0%26pg%3D2047675%26algv%3DPromotedRVI&_trksid=p2047675.c101196.m2219&amdata=cksum%3A2847876941269b063add50694dfdbe3d6fdd979f742e%7Cenc%3AAQAHAAAA8Iq9Pd1eiueKRlho1pRz6mLOxIIzUuHAsY%252BF7YWWcO2NjAM2cRu8HqLLSg26HeRuss4jEl5vP3WYWZk7WnYvCoIHgzgQJQRWQURZfZDKnb0GsSoPk2Io3LHwNWvj4jYdRYX%252Bv6x7qe930ZFxyt1js1g3x7jJ9LkndjFyo%252FYnu5RnszEqzxnku2b8huG%252FDpTI1I5p%252FalDhfP2m2ThrmsE6e0LJcTTuUsLOuShAZvNdqpKedbGHdIzg1TyZFmbRbsDv5aZFmILxjJYyLc1lmg5K%252Fq97UQ6Cg9bcynqiAVsk3BzDnH9oAFajR6pacQVGkx1eg%253D%253D%7Campid%3APL_CLK%7Cclp%3A2047675&epid=2244901463

Thanks.

4
People GT 300i / Re: Clutch removal tool
« on: September 18, 2022, 11:04:19 PM »
Quote from: Stig / Major Tom on July 06, 2022, 11:33:06 PM
My cyclepedia manual states 2mm is the service limit for clutch pads on a LIKE200i.
Stig
@ Stig
Are those cyclepedia manuals worth getting, I am looking at getting one?
Thanks.

5
General Discussion / Re: Covid vaccine and motorcycles.
« on: April 08, 2021, 08:49:28 PM »
Quote from: CROSSBOLT on April 07, 2021, 08:46:19 PM
Dolly in critical condition after second shot....

If you don't want to end up in xatans kingdom watch this video.

6
General Discussion / Re: Anyone purchase a new 5g phone?
« on: April 03, 2020, 04:11:47 AM »
Please inform yourself about 5g before using it.

7
Downtown 300 / Re: Anyone used engine oils other than 5W50? Whats your experience?
« on: December 16, 2019, 02:55:36 AM »
I've used 15x40 and now experimenting with 10x40.
5x50 is full synthetic. If you start with synthetic you should stick with it.

8
Downtown 300 / Re: Fuel Filter Bolt Nut?
« on: June 16, 2019, 01:17:59 AM »
Loosen the nut while the engine is cold, before you warm up the engine to do an oil change. I don't warm up the engine anymore to do an oil change but do it while it's cold. It just takes longer that's all.

9
Downtown 300 / Re: Does my belt need replacement?
« on: June 16, 2019, 12:48:53 AM »
looks o.k. but keep inspecting it every 3-5000km

10
People GT 300i / Re: Help! Won't start!
« on: June 15, 2019, 11:44:34 PM »
I had similar problem. Don't think i had that yellow light flashing. Took it to the mechanic, he looked everywhere couldn't find any electrical problem. He opened the throttle wide open and tried to start the bike for few seconds and it started while the throttle was wide open the whole time.

Had the problem again. I thought it was battery but used the same method and it started. He told me fuel injection gets flooded sometimes and that's the method you use. Keep the gas open all the way for few seconds till it clears the fuel injection.

I don't think the fuel pump on your bike was the problem, it was just guess work from their part.
What's the yellow light representation of?

11
People GT 300i / Re: Aftermarket Suspension
« on: November 30, 2018, 12:46:53 AM »
I am still on original maxxis rear tyre which has 26,000km, can't say I am not suprised. But I hardly use rear brake, most of the time let the engine slow the bike down. 15,000km is good too. Rubber wears out quicker than nylon.

12
General Discussion / Re: No People GT300i for 2018
« on: June 09, 2018, 01:59:48 AM »
It's also not available in Australia. Been replaced by x-town 300i and downtown 350i.

13
General Discussion / Re: Seat rebuild or new shocks for comfort?
« on: June 09, 2018, 01:56:28 AM »
You can put a pillow and underneath a mountain bike bicycle tube. It helps a lot. I've released scooters are not best when it comes to bumpy roads because of a riding position.

14
People GT 300i / Re: Raising front light beam.
« on: March 23, 2018, 09:50:11 PM »
Thanks for your help. Visually you can't see anything as you are turning the screw. That's why I was puzzled and thought it wasn't working. As you mentioned it's best to do at night against the wall or something.

15
People GT 300i / Re: Raising front light beam.
« on: March 15, 2018, 12:02:45 AM »
I've checked owner's and service manual nothing there. Tried turning the screw to the left but don't see any difference will double check. Thanks.

Pages: [1] 2 3