Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bpt323

Pages: [1] 2
1
Downtown 300 / Re: What did you do to your DownTown today?
« on: July 08, 2021, 03:35:36 AM »
put it up for sale,  not sure what i'll wind up getting for a 2012 with 13k miles on it. even heavy mods

2
trashed!!!

3
are you going to post additional photos????

4
Downtown 300 / Re: New Shad tunnel bag.
« on: August 14, 2017, 10:17:21 PM »
i dig it!!

5
last chance before it goes in the trash!!

6
price on the complete downtown 300i motor/ecu/harness?

7
Location: Madison WI  - USA
all items are best offer.

Stock exhaust
under-seat lifting shock
handlebar plastics
kickstand switch


8
Downtown 300 / Re: What did you do to your DownTown today?
« on: June 23, 2017, 06:07:55 AM »
Started installing HID's for HI's/Lo's  while i was investigating the best route/methodology i noticed the front turn signals within the headlight housing themselves were not actually wired up.  the power wire was shunted at the ground joint - has anyone else noticed this? i'm a little bit less than impressed with OEM's choice for doing so.

pictures to come ***

9
Downtown 300 / Re: Headlight halogen to LED conversion.
« on: April 09, 2017, 08:59:55 AM »
free bump to this thread. im looking to upgrade both low & high beams

happen to know if the high beam is the same as the low beam? h8 socket?

10
For Sale / Re: 2012 Kymco People 300 GTI GOLD/Orange
« on: April 09, 2017, 05:58:12 AM »
tempting!!

11
Downtown 300 / Re: Downtown for taller riders?
« on: June 03, 2016, 06:24:17 AM »
6' even 33 inseam.  I sit on the "hump" portion of the seat.  -eventually you get used to it altho it feels extremely awkward to get on & then reposition higher for the first few times.

12
Downtown 300 / Re: What did you do to your DownTown today?
« on: June 03, 2016, 06:20:12 AM »
Installed a Jcosta variator.... Holy crap this thing "woke up"  all in all - Despise being 350g on average heavier than the OEM variator.  Needless to say i am definitely impressed!
next mod is the rear sliding sheeve. anxious to get a more aggressively linear sheave to retain even more low end torque.
anyone else modding their transmission in this fashion?

13
Downtown 300 / Re: Hesitation during hard aceleration
« on: June 03, 2016, 05:33:38 AM »
on the map sensor.... I combined cleaning the tiny holes & slightly chamfering them with a razorblade.
I then rotated it about 45 degrees(if you examine the sensor itself you can only technically rotate it a certain amount of degrees before it forces itself out of place.
The hesitation became alot better.  altho it is most certainly still there....
Im anxious for someone to develop a standalone type of ECU for this thing that will allow tweaking & sensor checks.

anyhow the mod works, and certainly helps.

14
Downtown 300 / Re: DNA Air filters
« on: April 23, 2016, 03:44:04 AM »
how much of an improvement should/could we really expect from either the DNA/BMC filter?

15
thank you^

Pages: [1] 2