1
People 50 / Re: Re-jetting for new NCY exhaust
« on: July 23, 2016, 05:57:52 PM »
Yes, noticable increase in both pep and top end speed. Ordering jets this week to experiment. Also have the unrestriced drive boss ordered.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
People 50 / Re: Re-jetting for new NCY exhaust
« on: July 19, 2016, 03:12:12 PM »yes, exhaust looks cool, it was new for me. aftermarket main jets work OK, but I suggest buying the more expensive OEM idle jets. aftermarket idle jet didn't work for me. CheersThanks Chaz. You suggest bumping up the idle jet too, and not just the main?
Currently: Main Jet #85 / Idle Jet #35
Here's a pic. It's wifey's scooter - aptly named the 'Sherbert Express'
3
People 50 / Re: Re-jetting for new NCY exhaust
« on: July 19, 2016, 01:59:23 PM »Maybe exhaust OK, IDK. I have 05 People 50 2T, and got OEM Keihin jets from jetsrus.com. Look for Keihin PB16 jets, below is a link. If you can, measure your jets to be sure these jets fit your carb. Cheers
https://www.jetsrus.com/a_jets_by_carburetor_type/jets_keihin_99101-116_main_round_small_and_38-xxx.htm
Thanks for the info!
4
People 50 / Re: Re-jetting for new NCY exhaust
« on: July 19, 2016, 01:58:40 PM »hello ChuDog, welcome to the forum. Your exhaust looks like for 4T, and you have a 2T? Could be problem there?It is indeed a 2T pipe. I installed it last night, and it fit perfectly. NCY Item #0500-1046 Stainless steel with a nice polished finish. Runs good with the stock jet, but will report back with an update after trying out a larger jet
5
People 50 / Re-jetting for new NCY exhaust
« on: July 18, 2016, 06:07:15 PM »
Hi Everybody.
My first post. I'm reading that I should increase the min jet size to compensate for the new NCY better flowing exhaust. Went to my Kymco dealer, and they had nothing that would fit (the thread sizes were all too large). The stock size is #85, and I think I should go an #88? Do you know a source to order these? I saw some online, but hesitated to buy, not knowing if the threads would be the correct size. Thanks for your help!
2009 People 50 2T
NCY Exhaust
Stock Keihin Carb (Main jet #85 / Idle Jet #35)
My first post. I'm reading that I should increase the min jet size to compensate for the new NCY better flowing exhaust. Went to my Kymco dealer, and they had nothing that would fit (the thread sizes were all too large). The stock size is #85, and I think I should go an #88? Do you know a source to order these? I saw some online, but hesitated to buy, not knowing if the threads would be the correct size. Thanks for your help!
2009 People 50 2T
NCY Exhaust
Stock Keihin Carb (Main jet #85 / Idle Jet #35)
Pages: [1]