Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - KymcoSuperFever

Pages: [1]
1
Technical | How To / Having issue when Kymco ZX50 2005 Starting when hot
« on: August 11, 2017, 11:13:20 PM »
Finally was able to change off the spark plug, and machine is running great. When I go out to started every day starts right up. But after I run it for 15 minutes, go into store, come out, it takes forever to start up again. Just keeps turning over and over and over any ideas why? You guys are the experts. Thanks in advance!  8)

2
Technical | How To / Re: Super Fever ZX 50 Silly Question; Help
« on: August 11, 2017, 11:05:55 PM »
Fixed it. Actually went from underneath the Seat where there was room only when the main kickstand was up. It was still a real pain in a very tight spot. Then I broke ignition coilTrying to get it off and had replaced that what seemed like having to take half the bike apart to get to that part. Anyway thanks for your help

3
Technical | How To / Re: Super Fever ZX 50 Silly Question; Help
« on: July 26, 2017, 12:55:31 PM »
Thanks Tromper, I have the Original Manual; and the printed out the one you provided long ago and it Doesn't describe how to; Here is the page: it shows a picture of the spark plug, the Spark plug gap, the name of the spark plug, and tells one to take the cover off but doesn't tell one what else needs to happen –   I think this is an egregious error by them...

It did come wit but the plug wrench, its 2 1/2  inches tall and I have a one half inch gap, and there's metal about it so no room to stick it in, I will look again as I will not give up and I really appreciate everybody's help!

SEE PAGE IN MANUEL attached

4
Technical | How To / Re: Super Fever ZX 50 Silly Question; Help
« on: July 26, 2017, 12:09:01 AM »
Thank you for the reply. There's a metal bar above the spark plug, is less than a half inch room, there so there's not even enough room for the socket to go on top of it without removing everything above...

Someone mentioned that if the shock absorber Bolt was removed the engine with swivel and drop down…??

5
Technical | How To / Re: Super Fever ZX 50 Silly Question; Help
« on: July 16, 2017, 10:22:15 AM »
Plenty of Room, but that is at the bottom of the bike. There is a steel plate also that separates them.

Spark Plug is at top of engine; it's exposed but about 1/2" clearance. No room at all to remove/replace Spark Plug; see photo posted in previous post.

Thanks.

6
Technical | How To / Super Fever ZX 50 Silly Question; Help
« on: July 15, 2017, 06:36:48 PM »
Trying to replace the spark plug ( Kymco Super Fever ZX 50 2005 ) but there's no room to put the socket in; does the engine have to drop to replace the spark plug? I did a search on this board and everyone talks about replacing the spark plug but I didn't see any instructions, did a YouTube search, google search and nothing seems to come for this particular model.

If someone could explain the easiest way to access the spark plug so I can get the socket in that would be wonderful. Sorry for such a basic question  :0)

Thank you in Advance!  A Kymco Fan

Pages: [1]