1
Side By Side / Re: Just got the motor back
« on: July 11, 2018, 07:01:00 PM »
Thanks guys
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Side By Side / Just got the motor back
« on: July 10, 2018, 04:39:11 PM »
into this side by side and all hooked up and I have a wrench lit on the dash ? Anyone else have seen this ? let me know .
3
Side By Side / Re: utv has power to the injector
« on: July 09, 2018, 07:55:56 PM »
Anyone have a wiring diagram for these ?
4
Side By Side / Re: utv has power to the injector
« on: July 06, 2018, 07:02:02 PM »
This thing ran fine even with a busted tranny , rebuilt it and motor back in frame and has good spark and will run if I drip a bit of gas in the injector hole . but will not trigger the injector . Where does the injector get its signal , from the ecm . what are the triggers that make it possible ?
5
Side By Side / Re: utv has power to the injector
« on: July 06, 2018, 05:08:28 PM »
no fuelm to the motor ? ground the not hot side with every thing powered up have fuel pressure at the injector and good spark and compression just no fuel . any ideas
6
Side By Side / utv has power to the injector
« on: May 24, 2018, 05:15:07 PM »
wont open . what can I do , should be a ground signal right , so if I ground one side it should trigger the injector . Any ideas ? let me know .
7
Downtown 300 / Re: Hello from Winnipeg, Manitoba, Canada.
« on: May 24, 2018, 05:01:14 PM »
Welcome from a former Winterpegger now in Oklahoma .
8
Side By Side / owners manual online
« on: October 20, 2017, 03:09:16 AM »
Anyone know where to find one for the 700 ? Thanks
9
Side By Side / how hard is it to get the motor out
« on: October 17, 2017, 07:47:59 PM »
Kymco uxv 700 , needs to slide one way or the other to disengage the drive shafts . Any experience ? Tia
Pages: [1]