1
MXU / Re: Fuel pump
« on: December 13, 2017, 03:33:20 AM »
Fuel pump is easy enough to check, but even simpler.....crank it for 20 seconds then pull the plug to see if it's wet.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
MXU / Re: MXU300 only has reverse
« on: December 11, 2017, 02:38:51 AM »
Hey, any response is a start...I appreciate it! From what I see, it's the same engine as the Arctic Cat Alterra 300. I've been looking at some fiche, I'll probably pull the gear case tomorrow and have a look. I know the linkage is off a bit because it would light neutral in reverse, but that doesn't explain not grabbing a gear with the linkage off.
3
MXU / MXU300 only has reverse
« on: December 09, 2017, 04:11:59 PM »
Josh here from the sunny state of FL. I'll start by saying that I've been maintaining my own machines for 30 years, so I know my way around an engine. I've always had chain driven sport quads though, my only CVT is on my Rhino, and I've never owned a Kymco. I just bought an 09 MXU300 as an upgrade for my son for a steal. It's super clean and starts right up, but will only go into reverse. I pulled the linkage off and shifted the transmission by hand. It would still only catch reverse. When the machine is off, I can put it in H or L by hand and feel/hear the transmission spinning. Neutral works fine. If I hand shift it into H or L when running, it rolls like it's in neutral. If I add throttle, there is no noise or movement. If I roll it forward or back with slight throttle while in gear and running it sounds like something is binding. I'd appreciate any suggestions before I start tearing it apart!
Pages: [1]