Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Maxxer450

Pages: [1]
1
Technical | How To / Re: 2016 UXV 500i fault code P1110
« on: January 24, 2023, 03:35:06 PM »
I should have mentioned I have a service manual however the actual 'P1110' was on the bottom right of the display so no need to count CELP flashes.

2
Technical | How To / Re: 2016 UXV 500i fault code P1110
« on: January 24, 2023, 03:18:36 PM »
I'm a little late on this topic but the P1110 code just came up on my atv.  I was tracing out a wiring problem and had not reconnected the rollover sensor.  Plugged it back in and code went away.

3
MXU / Re: Maxxer 450i question
« on: January 30, 2018, 02:30:16 AM »
Just seen this but I have a 2014 Maxxer 450i that is running so might be able to help with future questions.  I have identified some part description and numbers by using the diagrams on this site https://www.united-cycle.com/OEMpartfinder.htm#/Kymco_USA/LC90BA_MAXXER_450i/F20_-_Harness_Wire/04%7C~22%7C~0005/04%7C~22%7C~0063
you will need to change the assembly drop down for other sections of the machine. Good luck!

Pages: [1]