1
Side By Side / Re: 450i CLEP light (check engine light) stays on??
« on: April 02, 2018, 10:57:52 PM »
Thanks for the advice, I will test the temp, order the sensor, and try again.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Side By Side / Re: 450i CLEP light (check engine light) stays on??
« on: March 31, 2018, 01:10:22 PM »
Put it back together after running a hose through and the light is still coming on? It just stays solid after about 2 mins of running. Water is circulating, fan works, thermostat is working. I don't know what else I can check, the gaskets looked good on the thermostat and pump housing!?
3
Side By Side / Re: 450i CLEP light (check engine light) stays on??
« on: March 25, 2018, 02:55:11 AM »
I tool the Stat out and it didn't look like it was circulating. I took the housing off the pump and everything looked good, pump spun fast. Tomorrow I am going to check where the hose runs from the pump to the top of the cylinder and out to the Stat. Would there be some kind of valve up there some where?? It seems like there may be now flow through the head area?!
4
Side By Side / Re: 450i CLEP light (check engine light) stays on??
« on: March 21, 2018, 12:24:00 AM »
so it overheated the next day, the seller told me that it overheated on him in the winter when he was plowing and he flushed the system and replaced the thermostat and it never did it again. When i took the seat off i noticed that the lower hoses on the thermostat were hot the top hose not so much. When i opened the radiator cap the water was cold! The seller told me that he inspected the shaft and impeller for the water pump and it appeared to be ok. He has offered to pay for any parts needed. I haven't had time to inspect the water pump myself, but assuming it looks OK what else could possibly be faulty?
5
Side By Side / 450i CLEP light (check engine light) stays on??
« on: March 15, 2018, 02:47:19 PM »
I just bought a used Kymco UXV 450i, When i got home a rode around for about 15 mins and the CLEP light came on and did not blink, just stays solid. I am going to check it when i get off work, the guy i bought it from said he had never seen the light come on before. Can you test this with a normal car code computer? it didnt sound any diffrent when the light came on? It does have aftermarked LED lights on it that were cutting out when i hit bumps, maybe it has a bad ground and that would turn the CLEP light on??
Pages: [1]