Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Hans

Pages: [1] 2
1
Xciting 500 / rear brake problem
« on: November 11, 2012, 08:18:31 PM »
Hello, Ihave a major problem withmy xciting 500 2005 .

i have changed the brakepads with the original ones and used the book from  kymco , after i had changed the pads the brake pads are pushing the disk and i am worried now that the brake disk is overheating .
i can turn the wheel with one hand but there is resitance .


please i need advice i use the machine for driving to work every day about 175 kilometers.


thank you verry much

Hans (holland)

2
Xciting 500 / Re: problem when speed go's up
« on: June 23, 2012, 05:40:27 PM »
solved

hi there i have solved the problem , it was the shutter in the carb the fuel was going in but it did not close so to much fuel consumption  i cheked te top cap and opened it and had a lot of trouble to fit the rubber membrame inside but problem is solved

thanks

sorry for the bad writing


Hans

3
Xciting 500 / Re: Needles Don't Sweep.
« on: April 05, 2012, 09:34:17 AM »
Hi there, the only time when it swept on my xciting 500 is when your battery is allmost emtpty both needles are the sweeping up and down .
the other thing that happens is that the trip counter the is resetted .

after i installed a new battery it was gone


greetings

Hans van der Meijden
Neterlands

4
Xciting 500 / Re: Brake starter switch
« on: April 05, 2012, 09:26:34 AM »
Hi there,
the start will only work if the brake light is powered , but first i have a question , when you use the left brake is there no brake light or is it flashing when pul it on and off ?

Ihad the same thing and i have replaced the switch for new ones not so expensive and no more surprises.

if you want to know the part number just give a reply with type and year.


greetings

Hans van der Meijden

Netherlands

5
Xciting 500 / Re: Replacing brakes...
« on: April 03, 2012, 05:53:35 PM »
hi there, when you buy new pads watch for the little pin on the pads for rear brake because the pin  is used for the hand brakesystem.
you can not use these on the front brakes or you have to get the pin off the pad


sorry for my bad englisch

6
Xciting 500 / problem when speed go's up
« on: December 10, 2011, 09:11:00 PM »
Hello, i have a problem with mi xciting 500, when i want to overtake a car on the highway while going 120KM/h the machine won't speed up when give full power but after about 20 seconds it go's like hell without warning.
it happens only when the outside temp is verry low.

is there anyone who has an answer  ?

greetings from Hans van der Meijden (netherlands)

7
Xciting 500 / New parts
« on: July 14, 2010, 09:35:36 PM »

This is the story,
A few monts ago i bought a xcting 500 in belgium and get her thru customs and i dit a little resarch on the machine, now ater about 2500 km's i had the feeling that there was something wrong with the clutch so i opened the vario cover and tried to remove the nuts from the clutch that was heavy but it went of.
i took of the cover and the shoes lookt verry normal but i renewd the whole with the original parts the spring included.
next i replaced the rols and sliders in the vario .
after that was done i replaced the brake pads in the front and rear , there was a little problem with te pads , i ordered by germany 3 sets for the back wheel ,there is only one tiny point on the back blocks and that fits in the handbrake adjust part.
thats the only thing between front and the back brake , with he ginder make it flat and they fit at he front too and you save lots of money.
i changed the oil and filter .
and then i went for a test drive ........guess what    AWSOME

the rpm went down with about 750 and it drives super


Greetings  Hans van der Meijden (the Netherlands)

8
Xciting 500 / Re: Exhaust Heat Shield
« on: July 10, 2010, 05:36:42 AM »
do you need the original part?

Hans

9
Xciting 500 / Re: trailer hitch
« on: June 12, 2010, 04:37:34 PM »
take a look at the link : http://www.tourmaster.nl/Trekhaken.htm

is this something you want


Hans

10
Xciting 500 / Alarm with remote start on my XCITTING 500
« on: June 12, 2010, 04:34:56 PM »
today i have installed my alam with remote starting on my machine and guess what ,,,,it works perfect.
the system that i have is a SPY 5000 if you have any questions about the connecting i wil answer

Greetings


Hans

11
Xciting 500 / Re: trailer hitch
« on: June 08, 2010, 03:09:11 AM »
sorry 

12
Xciting 500 / Re: How much to replace all the plastic?
« on: June 06, 2010, 06:18:07 AM »
http://www.kymco-ersatzteile.de/shop/catalog/default.php?cPath=101

13
Xciting 500 / Re: trailer hitch
« on: June 06, 2010, 05:59:13 AM »
something like this?

http://www.laurieraanhangwagens.nl/page4.php


Greetings from Holland

Hans

14
Xciting 500 / Re: shaking front wheel
« on: June 02, 2010, 11:20:42 AM »
the problem is solved, it was actualy verry simple just the tire turned on the wheel and on the balance machine only 5 grams  and it was gone


works perfect

Hans

15
Xciting 500 / shaking front wheel
« on: June 02, 2010, 05:53:47 AM »
Hello, does some one know what is the cause of the shaking of the front from the xcitting 500 .
when i close the throttle and the speed goes down at 60km and i hold the steering slidey loose in the hand then it starts to shake

Hans

Pages: [1] 2