Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bigtexan99

Pages: [1]
1
People 50 / P50 starts and idles, but boggs down if you give it gas
« on: March 06, 2011, 02:58:03 AM »
The 2004 People 50 has not seen much use this winter.   Tried to start it a few days ago and it will turn over and idle rough.  If you twist the throttle with the bike on the center stand, it just bogs down and dies.   I tried this more than a few times.

The next day, I went out and tried it again, and it started (with a kickstart, the battery is dead) and idled.  I twisted the throttle and it revved up and I held it at about half throttle for 4-6 minutes.     Smoky white exhaust that cleared up a little.   After about 5 minutes, I let it idle down.  When I tried to give it throttle again, it bogged down and died.

The next day, I started it, and after a few attempts was able to get it to rev up.   I jumped on it, and was able to ride it around the block at half to 3/4 throttle.   Got back to the house and idled.   You guessed it... any attempt to give it throttle causes it to bog down and die.

What's up with that?

2
People 50 / Re: Headlight only works on 'pass', not on low or hi
« on: August 11, 2010, 05:42:04 PM »
Thanks, I'll go look for that manual.   It's actually a friends scooter.  I have an older Elite 250.  I like the Kymco though.

3
People 50 / Re: Headlight only works on 'pass', not on low or hi
« on: August 11, 2010, 01:35:53 AM »
That was it!  I never noticed that switch on the right hand side.  My lights now work as they are supposed to.  I suppose if I had a owners manual I could have read about that.

Thanks!

4
People 50 / Headlight only works on 'pass', not on low or hi
« on: August 10, 2010, 11:44:01 PM »
My 2004 People 50 headlight switch has 3 positions, low, high, and pass.   The switch can be put in either the low or the high position, but you have to hold the switch in the 'pass' mode.

The headlight only works in the 'pass' mode.   As soon as you let go of the switch, the headlight goes out.

All other lights and blinkers work normally.

Any ideas how to fix?

Pages: [1]