1
Venox 250 / Re: 2008 Venox 250 Idling problem
« on: September 04, 2018, 08:13:31 PM »
Thanks Robert. Air filter and plugs are good.
Cheers.
Cheers.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Venox 250 / Re: 2008 Venox 250 Idling problem
« on: September 04, 2018, 04:37:20 PM »
The pictures of the hoses was very informative, unfortunately all my hose connection are as per the pics. Bike still not idling without choke.
Thanks for the prompt and very useful info though. Any other ideas would be most welcome. Can't find any external air leaks.
Regards,
Thanks for the prompt and very useful info though. Any other ideas would be most welcome. Can't find any external air leaks.
Regards,
3
Venox 250 / 2008 Venox 250 Idling problem
« on: September 02, 2018, 07:10:39 PM »
I have a 2008 Venox 250 with only 950 Klm (yes nine hundred and 50 clicks). It's been stored and I left bad gas in her.
Removed the Carbs and cleaned all jets, orifices etc, etc three times. Fresh gas. Tested vac fuel valve all good.
She will only run on full choke. When choke is closed she stalls. Turning in air screws make no difference. Ran her around the block a couple of times with choke off and bike runs ok. Will not idle, even with idle adjust knob turn in full. Screws are backed out to 2 turns.
I have the service manual, unfortunately it's not much use, in my case. Does not even have a hose routing diagram, and the one under the seat is not as fitted.
My assumptions;
Only idles with choke on is an indication to much idle air. Turning in screws makes no difference.
Or I have an air leak. If anyone can provide a detailed emissions control hose diagram would be extremely helpful, or if anyone has experienced the same problem kindly let me know.
Thanks to all.
.
Removed the Carbs and cleaned all jets, orifices etc, etc three times. Fresh gas. Tested vac fuel valve all good.
She will only run on full choke. When choke is closed she stalls. Turning in air screws make no difference. Ran her around the block a couple of times with choke off and bike runs ok. Will not idle, even with idle adjust knob turn in full. Screws are backed out to 2 turns.
I have the service manual, unfortunately it's not much use, in my case. Does not even have a hose routing diagram, and the one under the seat is not as fitted.
My assumptions;
Only idles with choke on is an indication to much idle air. Turning in screws makes no difference.
Or I have an air leak. If anyone can provide a detailed emissions control hose diagram would be extremely helpful, or if anyone has experienced the same problem kindly let me know.
Thanks to all.
.
Pages: [1]