KymcoForum.com

Problem fixed. Impact wrench to rear tire to remove tire, never got to the point of removal. Wheel started free spinning after massive vibrations of air wrench. Must have been the brake shoes jammed. Readjusted brakes...


Sent from my iPad using Tapatalk

I wonder if you have a problem at all.... The scooter will dim the headlights when the engine is at slow idle as a normal operations process. Pay attention to the idle sped when it happens.


Sent from my iPad using Tapatalk

If your deaf you never have to worry about noise! just try fitting a cochlear implant head piece under a helmet!

I had some of the same issues on a people s 200. I found that the battery had a week cell and it still showed 12.5 volts, just not enough amps. Also check for ground faults between battery, starter, and frame. I used a pair of jumper cables to bypass each area and found the problem. also check starter wiring for faults. All i did for this was to go through every connecter and pulled and repluged after using dielectric grease. also a good idea for all electric connections.

Thanks for the hint about the harness near the front end. Thats one i need to check out. Its got to be something like that because as I was working on it today, the problem got a little better( a bit more power to the front end) for  reasons I cant figure out otherwise. I still cant find the frame to engine ground but when I check for that it seems o.k.------well, i'll start ripping off the harness covers on my next day off!

Thanks for all the help!

People s 200--2008

Battery is new and good, all connections are tight and clean, the part im looking at now is the starter solenoid, it is the only part that covers all three parts of my issues , 1-brake light switch.2- powerto the front end. 3- faileur to engage the starter,

i've got an 08 that started off with what seemed like ground problems and i think that was part of the problem but as time went on the issue of the starting has gotten worse, every time i go to start the bike it gets weeker on elec power in the front end.... no lights ect. no start. now its got no power at all to the fron† of †he harness .   any help with which part would slowly burn out and cause this? at this time im starting to check parts however im lousy with a meter and elec. issues. i do have a complete manual but could use some real help////thanks
 aslo this may or may not be a issue, the bike was blown over by a strong wind and almost fliped totaly over .
I get a dash light when the ignition is on but it dies when i grab the front brake.

people s200 2008

I disconnect the charger before starting so that i dont kill the charger or the scooter. At this point I'm leaning to the starter selinoid. im not getting goo starter operation even when crossing the posts