Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnb34

Pages: [1]
1
Technical | How To / Re: fuse blowing
« on: January 22, 2011, 08:28:50 AM »
Thanks for the replies I am going to have another look at it later. The bike is  a 2003 kymco pulsar. just befor the fuse blows i can smell electrical burning so will see if i can locate where that is coming from. I am wondering if it could be the starter solinoid being faulty. will let you know how i get on.

2
Technical | How To / fuse blowing
« on: January 21, 2011, 06:22:12 PM »
Hi all my ignition fuses keeps blowing without the ignition being on and was wondering if any one might have any ideas what might be the cause of it? I started the bike yesterday as normal and it ran on tick over for about 5 mins then cut out and would not fire again again later when i went back to look at it there was no power when i turned the key on due to the fuse being blown now the fuse blows with the ignition off. Thanks John

3
Technical | How To / 2003 pulsar charging probs
« on: September 15, 2010, 07:15:44 PM »
Hi I have a 2003 kymco pulsar 125 which is  not charging I have put a new battery in but that has gone flat to  I was after some guidance on what might be the most likely cause of this and how to go about rectifing it, I also wondered if any one knows of a repair/workshop manual for this bike the only thing I have found is a manual for chinese motorcycles  which is being released soon. Thanks John

Pages: [1]