1
General Discussion / Re: Rear brake caliper
« on: February 22, 2024, 02:41:04 PM »
Hi all went subito .it no luck there getting the caliper of is a real headache for me anyone got another suggestion thanks
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
2
General Discussion / Rear brake caliper
« on: February 20, 2024, 04:13:34 PM »
Hi all i have a question will anybody know if a rear brake caliper from another kymco/ or other scooter will fit my 2015 kymco400i i have hunted hi and low cant find a used one and new over 200 British pounds i only really nead the caliper hanger any thoughts from anyone thanks in advance
3
Technical | How To / Re: Engine management light
« on: September 27, 2020, 01:11:42 PM »
Hi all tryed the method it worked a treat many thanks
4
Technical | How To / Re: Engine management light
« on: September 26, 2020, 09:10:17 PM »
Kymco400i 2015 yes the light that is shaped like an engine not blinking or flashing I turn the scooter on and the engine light mist stays on I have risen it up and down a bit it seems fine
5
Technical | How To / Engine management light
« on: September 26, 2020, 04:37:22 PM »
Hi all on the way home from work I could smell coolent one of the jubilee clips was loose I was less than half a mile from home so carried on so as I pulled up the temp was flashing hot and the engine light came on so I refilled with coolant all was fine but the engine light has stayed on anyone know how to clear it thanks in advance
6
Technical | How To / Oil service light
« on: September 24, 2020, 05:13:29 PM »
Hi all will anybody here know how to reset the oil service light on my kymco400i I don't have a workshop manual I have reset it a long time ago but cant remember how to do it is it both buttons or 1 button both together or separately any help welcome thanks in advance
7
Technical | How To / Elt roller change
« on: September 21, 2019, 12:13:30 AM »
Hi all I have the kymco400i has anyone on this forum had any experience at a belt and roller change if so any advice tips pictures etc would be great as i have never done this before and can't find anything on YouTube and will need doing soon thanks in advance
8
Technical | How To / Re: Starting issues
« on: August 04, 2019, 08:57:20 AM »
The ls for the help buys
9
Technical | How To / Re: 7 mos on a tire plug
« on: August 04, 2019, 12:03:55 AM »
Changed my rear tyre on Oct first 2017 got a screw in it next day put a tyre plug in it it lasted the life of the tyre that was on a cbf 1000
10
Technical | How To / Re: Starting issues
« on: August 04, 2019, 12:01:17 AM »
Not checked if the brake light comes on but will where is the switch located thanks
11
Technical | How To / Starting issues
« on: August 03, 2019, 06:13:49 PM »
Hi all need some help so I put the key in turn dash lights up pull the left hand brake on then nothing happens so release left brake and pull the right ha d brake on then push the start button then it starts but won't t start pulling the left brake anyone got any ideas thanks
12
General Discussion / Tourqe settings
« on: May 28, 2019, 08:12:06 PM »
Hi all will anybody know the tourqe settings for the variator and clutch for my 400i xciting I have looked around the internet but can't find the information I need thanks all
13
Technical | How To / Re: Gas mileage question
« on: May 25, 2019, 12:02:41 AM »
hi i have the 400i and i am no lightweight on the scooter my tank holds 12.5 litetrs of fuel on 12 liters i get a consitant 200 miles between fill ups at an avrage of 60 mph
14
Technical | How To / Re: Dash cams
« on: May 24, 2019, 11:59:08 PM »
400i 2015 i was going to use the earth from the battery and then remove the 10amp fuse put the live in that space and put the fuse back in as the 10 amp is the ignition it should go on and off when the bike is started and switched off
15
Technical | How To / Dash cams
« on: May 12, 2019, 08:22:45 PM »
Hi all has a body fitted a dashcam front a d rear to there scooters if so could you tell me which wires you used for the live and earth as I think king of fitting one myself thznks
Pages: [1] 2