Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - nut

Pages: [1]
1
zx50 / has any one tried 5g rollers n there zx 50
« on: January 03, 2011, 11:01:01 PM »
I orderd some 5g roller n got the other day I put them in today my old roller wear flat spoted bad but I took it for test ride n it suckd it had really good take off but after 20mph it just did have no power n it up hill didn't improve very much in I went from down hill top end of45 to47mph to not even get n 40 idid clean every thing and scoch brited every thing n took cluch cover off cleand it n320grit over pads and the cover I did put tiny bit of grease on the ceanter rod n the vareator just cause it wasn't moveing very freely but not part balt reasts on dose any one tried 5g rollers and the preform better then I described if so like to know speeds differnts or do any noe think I did something wrong

2
zx50 / what weight r the factory roller?
« on: December 17, 2010, 07:00:32 PM »
Fixn to order roller like to know weight of factory rollers I haven't tacken mine out. Yet so need to know befor I order

3
zx50 / will 15mm 12mm rollers work
« on: December 12, 2010, 06:29:29 PM »
I was given a set of 5g rollers but there 15mm by12mm. N the stoke size is 16mm by 13mm if. I use the smaller size will it work r would it be like the worn out stoke ones rwould it make it a little better mine have 26000kl on them so figured they probly about the size of the smaller ones but the 15mm ones r lighter just wanted to know if it b worth the time in puting them in tell I can get the 16mm ligh weight on

4
zx50 / what size roller weath and diamater r used on the zx 50
« on: December 10, 2010, 04:56:29 PM »
I want to buy a set of light but don't know what size will fit in factory vareator n like some info on what wieght to use

5
zx50 / variator derestriction?
« on: October 16, 2010, 10:43:15 PM »
How do I go about derestrictinng the variator n if it already is the cdi is don't iv had the cvt cover off but that's it. To cheak belt looks ok but want to know more on the to pully mainly the boss. But also the cluch can I take cluch cover off n sand in side n the pull with out it falling apart n the same wit the boss pully

6
zx50 / carb. info new with the zx50 need to know what the factery screw settings both
« on: October 09, 2010, 05:34:08 PM »
I need to know factery setting for the 2 screws on the carb. I messd with them and I'm. new with scooters n mean.   an :'(t running right n ithink that's got a lot to do with it and how do I get it to stop running lean help real don't know much about my zx50 on a long run then up hill it almost cuts off have to let allway off gas the play wit it then it acts like it cools down in its fin e just when under lode imodifide the air box but fix air flow with tape to make port smaler it workd fin tell. Imess with carb.

7
Technical | How To / 2005 super fever i modifide air box for more air but runs good then dies
« on: September 27, 2010, 02:12:35 AM »
When no air resrtions runs good for few mile then lose all power and has cut off like over heating

Pages: [1]