Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ScottNicol

Pages: [1]
1
Agility 50 / Re: Agility Ignition - Failed hot-wiring attempt & theft
« on: July 28, 2011, 10:09:43 PM »
The picture above shows my ignition switch but as you can see, they ripped the wires from the point they were soldered at on the switch itself, so I have no idea which wire goes where? I think there are at least 4 wires for this, hopefully 5 as I have an unmatched/spare wire.

My friend has the exact same moped as me, but he has gone on a two week holiday, otherwise I would have taken his front plastic off and checked which wire goes where (colour-wise)...

Not sure if anyone has the time to take their front plate off and take the pictures for me, the large manual doesn't cover this with all the electronic diagrams.

Thanks,
Scott

2
Agility 50 / Re: speedo stuck at 0mph
« on: July 27, 2011, 07:45:21 PM »
Yeah, the cable has broken at the end of the wheel, where it joins to the fork-style thing at the end... Anyone know where I can get a new one in the UK?

3
Agility 50 / Re: Agility Ignition - Failed hot-wiring attempt & theft
« on: July 27, 2011, 07:40:42 PM »
Thanks guys!

Thankfully the police recovered it, very lucky there! :/

I mean, if anyone has a picture of their ignition switch like the one above so I can match the wires up on it, that would be great! :)


4
Agility 50 / Agility Ignition - Failed hot-wiring attempt & theft
« on: July 26, 2011, 05:47:59 PM »
In the early hours of the morning today, a gang of youths ('chavs' here in the UK), stole my Agility 50 from my garden and broke both the steering lock and the front-end fairings to have a go at the electrics... All electrics are now rejoined but the ignition key and I was just wondering what wires go where?



I can get this fixed, but I just need to know the arrangement of the wires.

PS. Anyone know a good Agility 50 spares site (2007 model) for the UK? I need a new gearbox (rubber) gasket seal and perhaps a new front panel fairing.

Many Thanks,
Scott

5
Agility 50 / speedo stuck at 0mph
« on: May 30, 2011, 06:52:49 PM »
hi all!

my speedo on my agility 50 has been stuck at 0mph since yesterday. was riding home from work when i first noticed it, but my mileage isn't moving either. i undid the bolt holding the cable in place and fiddled with it, but no luck, still doesn't move... :(

anyone have any adivce?

6
General Discussion / Re: GOT TO LOVE TRAFFIC
« on: October 17, 2010, 04:51:02 PM »
Ha! I cut about 100 cars out in traffic the other day.



Very nice feeling! I bet the people in the cars were annoyed!

7
General Discussion / Re: your thoughts on 87 octane gas
« on: October 17, 2010, 04:45:55 PM »
I have an a50 (same year as wordslingers I think), and I run 95 octane, which is the lowest I can find. Premium is usually 99 octane, which my friend runs all the time with his two stroke. The bike I have must have done around 9km with 95 octane is it is the lowest around, no damage, and it's very quick off the line. I might try 99 octane and see what sort of performance increase/decrease I get, but I don't think it will harm it.

8
Agility 50 / Re: Front Brake Sqeaking
« on: October 07, 2010, 02:29:35 PM »
I get a really unhealthy sound while breaking. It's hard to describe... I'll get the service manual and see what that has to say too.

9
Agility 50 / Re: Front Brake Sqeaking
« on: October 04, 2010, 08:31:49 PM »
Cheers mate! I'll have another look tomorrow and get back to you. Is it possible to move the pads a mm away from the rotor or are they set?

Also, as a side note, I've checked the oil and cleaned the air box. Is there any other maintenance I should do?

10
Agility 50 / Re: Kymco CDI Derestriction.
« on: October 04, 2010, 08:29:09 PM »
I'll have a look at that this weekend as I have the weekend off. I don't have the tools to do the variator derestriction, but I know someone that might so I'll have to see!

Thanks all!

11
Agility 50 / Front Brake Sqeaking
« on: October 04, 2010, 07:20:26 PM »
Hello again! :)

My front brake whenever I pull it in and out of my drive and when I ride at low speed (< 10MPH), it will sqeak (really high pitch). I know it's the front brake as when I move it on its own (on the stand), it makes the noise. Do the brakes need bleeding or the calipers readjusting?

Cheers,
Scott!

12
Agility 50 / Re: Kymco CDI Derestriction.
« on: October 04, 2010, 05:47:55 PM »
I've cut into it, just as far as I know, it's a black wire. I'm not entirely sure, as I haven't cut it wide, just a slim cut. I can see some wire bit and I've gone about 5/6mm in already, is that normal?

It's getting dark now, so I will take some pictures in the daylight tomorrow.

EDIT:

I had a 'f' it moment, and just did a bit more cutting and then had a go. Immediately quick. Speedo said 40MPH, with a full tank and in the cold. Mighty impressed!

Thanks for the awesome resources around on this site, I can see some of the modifications coming in handy!

13
Agility 50 / Kymco CDI Derestriction.
« on: October 04, 2010, 04:31:47 PM »
Hi,

I have a Kymco Agility (mid '07) with a CDI (dated APR 2006). I can get more details of the box if you wish, but I don't know if this can be derestricted or not, and what wire I'm looking for. Do newer ones have the small wires to cut, and the older ones have a green one?

I normally do 35mph on straights, without any derestriction I know about. Hopefully be able to get it to a true 40 do you think?

Cheers,
Scott

Pages: [1]