Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Szpilu

Pages: [1]
1
Downtown 300 / Re: Slow acceleration to 5500Rpm and very slow above
« on: July 20, 2019, 08:31:38 AM »
The ordered variator house item number: 22110-LEA7 but my variator house is 22110-LGE5 what I need,the LEA7 the older variator vs my Downtown. Sorry if i wasn't clear.

It's was my mistake I didn't looked after what I need.

2
Downtown 300 / Re: Slow acceleration to 5500Rpm and very slow above
« on: July 19, 2019, 08:24:49 PM »
Fu....k The different: 22110-LGE5 what is the stock and what I ordered 22110-LEA7 code. I changed back the LGE5 variator house with the new belt+lighter rollers. And I can fly :D

3
Downtown 300 / Slow acceleration to 5500Rpm and very slow above
« on: July 19, 2019, 11:55:43 AM »
Dear All, I changed the Face drive+FACE COMP MOVABLE DRIVE+Belt(Gates). And buy a lighter rollers 14.5gr. But the scooter is very different the acceleration very slow to 5500Rpm then 5500-7000rpm more slower than the original setup.

What You think? the Original setup: Stock Variator Movable Drive+Face drive 15gr Dr Pulley rollers, Malossi belt,white malossi contrast spring.

4
Downtown 300 / Re: Sidelight-Led/SMD Led change
« on: July 09, 2019, 12:36:27 PM »
Okay, I did it last week. Unfortunately You must heat the headlamp in an oven with ten minutes on 100 °C, then You can easily disassembly the  lampshade then you see the led side light, 3 bolts hold the pcb, then you can soldering the smd. These smd are 4 pins. The common three points the positive side,and the one negative side.

5
Downtown 300 / Re: Overheating rectifier - solutions?
« on: May 21, 2019, 08:00:11 AM »
Quote from: mousejunks on May 21, 2019, 01:15:49 AM
Those voltages actually sound good. If starting issues remain you can check for corrosion on the starter motor terminal and the spark plug cap.

Hi. I changed the rectifier last weekend a new one. When the engine running the Voltage is 14,2V on the rectifier. And when I use the head lights and the rpm is 4-5000, 14,5V.


on the ebay there a new designed rectifier from the Kymco.

Link:https://www.ebay.com/itm/ENC-Regulator-Rectifier-REG-REC-COMP-ORIGINAL-KYMCO-31600-KED9-910-Xciting-250/291799405858




6
Downtown 300 / Sidelight-Led/SMD Led change
« on: May 20, 2019, 08:08:24 AM »
Dear All, somehow can I change the front sidelight smd-leds?on the left side two smd leds doesn't work.

Pages: [1]