1
Agility 50 / Re: Need help Agility 50 mods gone wrong
« on: July 06, 2019, 09:09:36 PM »
Top speed was about 40 mph. I mucked something up just don’t know what.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Agility 50 / Re: Need help Agility 50 mods gone wrong
« on: July 06, 2019, 02:00:55 PM »
Thanks, Stig. I was thinking the same thing (actually was going to replace one of the two and see if I got lucky). Hopefully someone will know what the issue is and save me a bunch of messing around but I appreciate your help.
3
Agility 50 / Need help Agility 50 mods gone wrong
« on: July 06, 2019, 04:48:09 AM »
Hey All,
Just swapped out two things on my 2014 Agility 50 4T. Only has 500 miles on it.
Replaced stock rollers with dr pulley roller sliders 6 grams. Replaced stock torque spring with a 1500 rpm torque spring. Put it back together and now I can only go about 10 miles per hour at top speed. Doesn’t sounds like I’m over revving at all or like engine is working hard.
Watched some videos and am pretty sure I got the roller sliders in the right way. Only thing I can think of is I couldn’t get the belt back on as it was too tight so I opened the rear pulley a bit so the belt would go deeper in the pulley and I would have some slack to play with. This allowed me to get the belt back on no problem.
Probably made a dumb mistake somewhere but took it back apart and didn’t see what I did wrong.
Thanks for any help!
Just swapped out two things on my 2014 Agility 50 4T. Only has 500 miles on it.
Replaced stock rollers with dr pulley roller sliders 6 grams. Replaced stock torque spring with a 1500 rpm torque spring. Put it back together and now I can only go about 10 miles per hour at top speed. Doesn’t sounds like I’m over revving at all or like engine is working hard.
Watched some videos and am pretty sure I got the roller sliders in the right way. Only thing I can think of is I couldn’t get the belt back on as it was too tight so I opened the rear pulley a bit so the belt would go deeper in the pulley and I would have some slack to play with. This allowed me to get the belt back on no problem.
Probably made a dumb mistake somewhere but took it back apart and didn’t see what I did wrong.
Thanks for any help!
Pages: [1]