3
« on: August 09, 2019, 07:48:27 AM »
Hey everyone.
I got a slighty annoying problem with a Kymco 300I downtown 2014.
After around 11.000+ km or just around 6800 miles the cable to the seat lock is beginning to fail.
as you may or may not know, theres a single cable going from the ignition and downwards. somewhere along the way the cable splits up into two. Now the problem is that the left side lock/cable cannot open using the ignition. No amount of tightening or loosening of it helps using the adjustment screws,
Either its to tight and the lock can engage, but then it cannot release or it´s too loose and the lock wont engage.
The right side started to do the same but, i was able to adjust the cable and it now works again.
Anyone with the same problem and a solution to fix that?
I know that a fix could be to replace the cables, but i was hoping for an easier fix than to disassemble the entire front and some of the middle parts of the scooter.
Thanks.
Tobu