KymcoForum.com

Whelp, the previous owner decided to remove the switch from the brakes so you don't need to pull them to start it. Also, I found that the starter relay is bad.

Turns out that Amazon has quite a few parts available through Prime! Should have her running this week.

Kickstart didn’t work either. I tried several times.

The dash instruments are working properly though, gas gauge etc.

Replaced my regulator. Connected the fully charged battery and it blew the main fuse again. Do y'all think I have a short somewhere??

I'm not great at the electrical side of things and I'm completely bewildered.

That explains a few things concerning the regulator/rectifier. It does get hot immediately ahem I connect the battery. And yes, the wire that is blowing the 7 amp fuse is hot as well. When I connect the battery and turn on the ignition, I hear a click sound in the rectifier.

From I can see, there are no is no wire insulation that has been rubbed off.

Does anyone know a reliable place to buy parts online? I recently purchased some mirrors and a blinker from kymcousa.com. I’m open to reliable online store that others have had good experiences with.

Again, I appreciate the replies and help. Thank you

Scooterfan, thanks for the in-depth reply. I’m working without a manual currently so I’m not 100% sure about a few things. Your guide of 1-5 helps tremendously.

Can you tell what size fuse should be installed? There are two on this scooter in the battery box. One on the red wire and one on a black.

I did hook up the battery and pulled in either brake with the ignition on. Neither brake allowed anything to happen with the start switch or lights. One thing to note. The red wire fuse seems very hot.