Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnb

Pages: [1]
1
Xciting 700i / Re: stalling with new cam sensor
« on: December 10, 2019, 06:09:14 AM »
I've never seen a cel on it.... was looking for it to throw a code I'll try again tomorrow, I put it on the trickle charge tonight, I'll see if it gives me a cel tomorrow will update this thread. thanks for the help.

2
Xciting 700i / Re: stalling with new cam sensor
« on: December 10, 2019, 01:12:05 AM »
so heres where I attached the new cam sensor, and in my hand is the old one, I suppose if the other one is the same then I'll just move this old one to the crank sensor' supposing this one is good, didnt wanna tear it up again as it was a pain yesterday to remove, had to remove 3 panels a footpeg and the grab bar.

dont suppose you guys have a pdf file for the service manual on this do you?

3
Xciting 700i / Re: stalling with new cam sensor
« on: December 09, 2019, 09:55:38 PM »
I'm in pasadena, I installed the new one in that spot same as in the picture by the right footpeg, is the there another location on the bike?

4
Xciting 700i / stalling with new cam sensor
« on: December 09, 2019, 12:29:42 AM »
just bought a myroad , installed a new cam sensor and it wouldn't run more than a couple seconds. what else should I look out for?

I used to have a xciting 400 before that had a bad stator, would this also be a possibility? or a bad spark plug? when I test rode this bike a month ago it was able to run at least for a couple minutes before dying.

Pages: [1]