Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Lang01

Pages: [1]
1
Side By Side / Re: UXV 500
« on: December 30, 2019, 09:47:09 AM »
Thanku appreciate the feed back.
I have pulled all the top end down all looks good.

It looks like the pump pumps from the pump to the oil cooler through the filter up through the cylinder into the head which is all clear and I've blown through. It has nothing( (No oil) at the oil cooler and filter. No doubt something I have assembled wrong but I'm still thinkin maybe the preasure relief valve not seated or maybe not in however we didn't remove anything other then the crank in the crankcase but the case did go to the engine shop.



2
Side By Side / Re: UXV 500
« on: December 29, 2019, 04:04:45 AM »
Also oil pickup screen

3
Side By Side / UXV 500
« on: December 29, 2019, 02:46:06 AM »
Hello all I'm new to the site.
I have a UXV 500 with little to no oil preasure.
We have just rebuilt engine which included crankshaft.
When engine is started it pushes a slight trickle out of the oil cooler hose and hardly enough to fill the oil filter.
We have checked and blown through all lines from the oil pump.
Checked oil pump to make sure within spec and direction.
Running 15w 40 oil
I'm thinkin oil preasure relief valve but looking for ideas possible checks.
TIA
Keith


Pages: [1]