Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - stupiddad

Pages: [1]
1
Technical | How To / Re: KYMCO MAXER MOBILITY SCOOTER ELECTRICS
« on: February 21, 2021, 11:53:00 PM »
Thanks for the reply.
Unfortunately user manual only available document I can find, tried everywhere I can think of scribd etc. That site is worth checking if you don't know it, free trial will get you lots of downloads.
Hope it doesn't rain tomorrow, she doesn't even let me fix her s*^t indoors and the garage is set up for the gpz at the moment.

2
General Discussion / Re: Oldest Riding Kit still in regular use?
« on: February 21, 2021, 12:46:11 PM »
Bought a pair of good boots with steel kick plate and toes, about '66 i think.
Replace the kick plate twice but the boots are still good.

3
Technical | How To / Re: I thought this was a throttle lock....
« on: February 21, 2021, 12:34:14 PM »
In my day correct usage and accuracy were not considered minor details but necessary fundamentals for communication.
Cacography creeps in unless we are ever vigilant.

4
Technical | How To / Re: PLEASE HELP!!!
« on: February 21, 2021, 12:24:56 PM »
If you haven't done this already here is a check worth doing.
get a clean container and remove the fuel feed pipe, let it run for about 30 seconds.
If you have a bit of crap near the tap or filter the fuel will run less or stop altogether. Doesn't take long and its free.
I once had a bead in the delivery pipe after painting the tank, idled fine but wouldn't rev.

5
Technical | How To / KYMCO MAXER MOBILITY SCOOTER ELECTRICS
« on: February 21, 2021, 12:03:27 PM »
Hi
My better half has no headlights on her Maxer Scooter, this is not an easy issue to chase.
Fusebox behind front cover has two power supplies each supplying 3 of 6 fuses.
Lights side is left indicators, right indicators and the third marked headlights. Both left and right indicators work front and back and rear lights work, not if headlight fuse removed, but no front whites.
The scooter is a bitch to undress and chase the wiring, I have worked on a few things in my time and am not kidding about the difficulty.
Any advice would be appreciated and a wiring diagram would be marvellous.
Been riding a while and currently have a BSA Bantam and a GPZ 400 I am refurbing for a grandson, when i finish that I will rebuild my hardtail XS650 so I have my share of spanner scars.
Kymco don't seem to want to help when I phone so  hoping you guys will.
Thanks for your time.

Pages: [1]