Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chrismoped

Pages: [1]
1
General Discussion / Re: Kymco Agility 50 Clutch Probelms
« on: April 27, 2020, 02:38:40 AM »
The rollers seem to be fine. Not too much wear and no flat spots.
Funny story.. when I bought the moped the previous owner said that it ran but hadn't been run in a while but everything worked fine. I rode the moped around town for a couple days without realizing what was in the rear pulley casing... An entire mouse nest! I had to clean it out and instantly saw better performance. I have noticed that the more I ride the bike the faster it is getting, I'm thinking the belt might have to be broken in but I'm not sure.
Thanks for the help

2
General Discussion / Re: Kymco Agility 50 Clutch Probelms
« on: April 21, 2020, 01:59:51 AM »
The new belt I purchased is the correct size. I was finally able to take apart the clutch, and as soon as I put it back together it started to expand and close as normal. I am still experiencing slower than average speeds and I can't figure out why. I'm happy that the rear pulley is working now so I can at least ride it at a normal speed. Before I took apart the rear pulley it was stuck in the open position so the belt would be loose. I am still experiencing trouble accelerating and top speed is not what it it should be (with the adjustments I made such as the new belt and the unrestricted CDI, I think it should be going faster than 25mph.) I'll have to keep tinkering with it to try and get it up to speed. Thanks!

3
General Discussion / Kymco Agility 50 Clutch Probelms
« on: April 06, 2020, 05:58:43 PM »
I recently picked up a 50cc agility. It was running fine, but it was in need of a new belt. The old belt was worn down from 18mm to 15mm. By hand we pulled the rear clutch/pulley in order to get the belt out. After we put the new belt in I have experienced difficulty accelerating and it sounds as if the belt is loose. The only thing I can think of is the fact that the clutch won't shut ever since we pulled it open by hand. Can anyone help? I've run out of things to try.
Thank you!

Pages: [1]