KymcoForum.com

I have two Agility 125's - I've put digital bicycle computers on both and calibrated them via GPS and my 23.2 mile commute to work for distance is spot on.   I'm 6'2" and 175lbs... both scooters pull about 54mph when I sit up tall, about 58 in a racing tuck and 62mph on steep downhills.

I have two Agility 125's and they are both a pain to start if they sit untouched for about a week.  Sometimes it takes me 20 minutes or more to get them to start after sitting for more than a week.  Often the battery runs out and then I have to Kick Start.   Seems like a wide open throttle during the starting process will help it catch and then it will idle for a few seconds before dying and then I restart and repeat the process until they run continous.  I don't know for sure, but my guess is the fuel lines get air in them causing a fuel starvation issue?  I hope somebody has a fix - my solution is to remember to start the bikes every few days to prevent the problem from recurring.

Problem solved - It was a wire harness that was mutilated during manufacture.  The ground wire leads for the tail light and the fuel sending unit were cut in half and another wire in the main harness was partially severed.  I got some wire connectors and spliced the wires back together and taped over everything - good as new!  The local Kymco dealer serviced the previously not working brake light by splicing in a new ground lead to the frame in the tail light pig tail connector, but failed to notice the non-working tail light - so basically they did a lazy fix and didn't find the mutilated wire harness.  Luckily this was covered under warranty and I did not have to pay for this!

I had to remove all the body panels from the scooter and trace the wires from the tail light to the battery...  The wire harness was butchered up behind the body work near the right side passenger foot rest area.

Removing all the body work was a little tricky but not too hard - just be careful not to force anything too much or you'll risk cracking the plastic.

I have a brand new 2008 model Agility 125.  Just started "scooting" with it, but the left rear turnsignal does not work.  The left front works but blinks really fast and after about 10 or so flashes it turns off.  The right side turnsignals function properly.

I checked the bulb - it is fine, I even swaped it out into the right side as a check and it works on the right side.  Did not check fuses yet, but assuming no problem as the left front is partially functioning.

Any ideas on what needs fixed/replaced?