Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Blaaze6673

Pages: [1]
1
Technical | How To / Odometer does not work on Kymco Agility 50 4T
« on: April 02, 2021, 01:25:29 PM »
Hi,

I have my Kymco Agility 50 4T scooter. Odometer does not work since front wheel was taken off.
'Experts' tried to fix this issue with no success.
There is a cable that connects to the 'speedo drive gear' on the front wheel. After I unplugged the cable from the speedo drive gear and spun the front wheel i noticed that the blad shape stuff  was spinning clockwise.

Any ideas what is wrong with the odometer? It must be caused by the assembly.

Kind regards,
B.

2
Technical | How To / Re: Kymco Agility 4T Cdi - Kill switch is grounded. Is it ok or not?
« on: December 24, 2020, 06:15:14 AM »
I replaced the existing used 3Ah battery with a new 6Ah YTX7A-BS battery which is recommended by battery store. -> Scooter starts, all is fine!

3
Technical | How To / Re: Kymco Agility 4T Cdi - Kill switch is grounded. Is it ok or not?
« on: December 17, 2020, 05:47:06 PM »
Ah, thanks! I'll look after a new battery and/or conductance issue with cables.
Kind regards,
Blaaze

4
Technical | How To / Kymco Agility 4T Cdi - Kill switch is grounded. Is it ok or not?
« on: December 17, 2020, 02:57:58 PM »
Hi,

I have 15 y old Kymco Agility 50 4T scooter that wont start from battery. It has new battery. It is suffering on battery start and produces weak spark.
I was wondering if my the CDI can be wrong or not since kick start is working.

The CDI of my scooter has 6 pins as follows:


Is it ok if i measure ground on KILLWIRE pin by default?

Scooter is running after kickstart and RPM control works. Can my CDI be faulty after all? I can get weak spark from battery start. I have new spark though

5
Technical | How To / Ignition fails to start Kymco Agility 50 4T
« on: December 15, 2020, 05:53:43 AM »
Dear forumers,

Ignition fails to start the engine all the time.
- new iridium spark plug,
- new fully charged battery Skyrich Li-Ion 12V/1,6Ah/96A then tried with used LP YTX4L-BS 12V/3Ah/35A AGM battery. Neither works.

Scooter is in a 15 centigrade garage. Engine easily starts from kicker but not from ignition system.

Video:

Is it battery issue?
Any ideas?

KInd regards,
Blaaze

Pages: [1]