Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - andrew22xc

Pages: [1]
1
A little update. I took the clutch bell off and sanded the inside, cleaned with compressed air/brake cleaner, and put it back together. I also completely cleaned the carb. No obstructions were found, but I cleaned it all anyways. A few notes. Can someone send me a picture of completely worn and shot clutch pads. they look fine to me but tbh I really dont know wat to look for. Also, I took the clutch assembly completely off and now that its back on, the main bolt tightens down a full one turn tighter on the threads. did i miss a washer in there somewhere?

My next step is taking the variator assembly apart and checking rollers, but does anyone have any other ideas? The belt looks great, but looks to me like its got alot of slack in the video.  I would like to remind everyone that this happened mid ride. no problem, then the problem just started at a stoplight.

No crashes. services have to be done by me, so not much besides fluids in that respect. I have learned alot owning this thing though. its been a fun ride. this is the first real problem I have had with it in over a year.

2
Hello all, thank you for your time.

This morning I was riding to the store and about 3 miles into my journey, with no irregularities, I stopped at a traffic light. The scooter was vibrating violently all of a sudden, and was requiring throttle to not die. Moving out of the stop seemed almost impossible. It took a good 10sec of full throttle to get up to 10mph, where the engine stopped shuttering and resumed normal acceleration performance. I pulled over and checked the stuff I know about, but nothing seemed wrong. Good fluid levels, tight seals on carb area, and no kinks in air or fuel lines I could see. Even checked the spark plug and cleaned it. It continues to have this engine rocking issue now, despite being normal this morning. Could it possibly be rollers in the CVT? Can those even go instantly bad during a ride? Could something have got into the engine, that muks it down at low rpms? Here is a link to a short video of the scooter cold idling just now -    Any leads would be appreciated.

Thank you.
Andrew

3
Agility 125 / Trying to find a seat hinge for a 2013
« on: February 28, 2021, 06:07:04 PM »
Bought an Agility that had been broken into and it doesn't have the seat hinge. I have been scouring the internet for the part, with no luck. Anybody know a place I could find one or something that would work well enough? Thanks for the help!

Pages: [1]