Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ironhorsecustomz81

Pages: [1]
1
Venox 250 / Venox and Magna
« on: May 18, 2021, 07:53:40 PM »
Has anyone noticed that Kymco was licensed by Honda and designed the Magna and thats why the venox looks so familiar? My buddy just did a rear wheel swap an exhhast mod using 97 magna 750 exhaust seat swap and forward control extentions that moved the controls 4 inches this is awsome news for us im gonna do some research and see what other mods can be done using magna 750 parts!

2
Venox 250 / Re: intake and exhaust valve settings
« on: May 07, 2021, 02:08:14 AM »
Quote from: yumzsmw on June 10, 2019, 08:56:22 PM
Intake and exhaust valve settings
0.03 for both

3
Venox 250 / Re: Kymco Venox won’t start
« on: May 07, 2021, 02:06:40 AM »
Check the starter selonoid under right side cover. Check for voltage coming into starter and voltage coming out when you push the start button. If you dont have voltage coming out when pushing the start button check smaller wire for voltage when pushing start then the problem is in the switch

4
Venox 250 / Extended forward controls
« on: May 06, 2021, 07:19:53 PM »
Ok guys so has anybody found or made any forward control extentions for a venox 250?
I have a set lying around from a 03 sportster and im thinking about seeing if i can revamp them to work with the venox. I already hot rid of the foot pegs and replaced them with foot boards. Any thoughts or advice before I start would be greatly appreciated.

5
Venox 250 / CARBURETOR HELP PLEASE!!!!
« on: March 01, 2021, 02:29:35 AM »
So I am pretty knowledgeable when it comes to mechanic work but I'll be damned if the Venox 250 carbs are just a pain in the ass. The service manual doesn't tell you where to measure from for float height. Just got it from a friend and it wont start. It sat for 2 years and when I got the carbs off one was was full of junk. So I cleaned em up real good and before i put the floats back in Id like to know how the hell to adjust the floats and tune the carbs. Like I said the manual is sh**.

Pages: [1]