Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Keoki71

Pages: [1]
1
Technical | How To / Re: What’s causing this loud noise?
« on: June 17, 2021, 06:10:33 AM »
Quote from: CROSSBOLT on June 16, 2021, 10:03:20 AM
Did you check or set the piston ring end gap BEFORE you put the cylinder on the engine?

I did, but it might had moved while I was putting the piston in the cylinder. Might go check on that and I’ll let u know

2
Technical | How To / What’s causing this loud noise?
« on: June 16, 2021, 09:42:50 AM »
I finally got my kymco agility 50cc running and installed a 80cc bore kit whole new top end, it has somewhat a hard time starting, but it ran a good 3-4 mins and starts to bog out while in idle, and making this loud noise , idk we’re it’s coming from. I posted a video, hope my kymco family help me out thanks a bunch!


https://youtube.com/shorts/S9Nnxm3ruWM?feature=share

3
Technical | How To / Kymco agility 50cc 2016 installed a 72cc bore kit and wont start!
« on: June 02, 2021, 10:11:02 AM »
i did everything right, i hope and the orignal head valves are on there,should i get new one? and top center i went with the timing part that holds the chain, due to my stator cover after u take the fan off is all rusted and i cant see top dead center, plz i need help

4
Technical | How To / Re: Need help asap
« on: May 13, 2021, 05:30:08 AM »
Thanks guys for reply’s and helping me out, but I am idiot found the solution to the nut that holds the gear and the variator was loose I impacted gun it, thought it was tight, as I start it the nut comes loose causing the fan to rub against the kick starter gears

5
Technical | How To / Need help asap
« on: May 06, 2021, 04:23:24 AM »
I’m new working on a kymco agility 50cc 2016 , I put a tight belt on my clutch and variator, there was no slack and that time I didn’t know anything, just order a variator and clutch performance kit and slap everything on, when I start it had a loud grinding noise, I crank it over couple times to see we’re the problem is coming from, my hunch was the variator so I put the old variator and old belt, and start it up and ran good few secs and made that grinding binding noise, so I’m at point I give up and throw the bike away, plz help.

6
Agility 50 / Need help my agility 50cc making a loud grinding noise
« on: May 05, 2021, 06:11:51 PM »
I’m new on owning a scooter and learning on YouTube to how fix my bike, I have a lot new parts in it already, recently order new clutch , new variator with weights and it came with a belt and the belt was a lot bit smaller then the old one, put it on and there was no slack, belt was tight, thought it was good put cover back and crank it over, made this loud grinding noise even my kick starter lever move on its own and got stuck. I put the old parts back on and still has that noise, I’m afraid I broke something. I greatly appreciate if someone can help me find a solution before I buy a new camshaft.

Pages: [1]