Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Manzat

Pages: [1]
1
People GT 300i / Re: Weird oil pressure light turns on
« on: November 14, 2023, 07:41:38 PM »
Hi everybody
My Kymco GT300i , year 2011 with  11000 miles.
 Since i bought this Kymco in may 2021 ( 8000 miles) ,  the oil pressure light has been coming on unexpectedly. Generally, after a cold start and after driving for a few hundred meters (but sometimes with the engine hot and the engine idling). I stop the engine. I need to start and stop the engine 3 or 4 times before the oil pressure light goes out. After that, no problem for hundreds of miles (or less). As if the oil pressure relief valve remained stuck for a moment.
Work done: need to dismantle the entire right side of the GT300i. I bought a new relief valve (ref: 15200-KED9-900); disassembly of the right engine crankcase; assembly of the new valve after checking that it slides correctly; right crankcase reassembly. Road tests and driving (1000 miles) since. No problem. No unexpected lighting of the oil pressure warning light.
Warning: First of all, if the oil pressure warning light comes on, you must stop the engine immediately and carry out the following checks: Check the oil level, the quality of the oil, the oil filter, the noise of the engine (abnormal or not). Ask for advice
Can be useful .

2
People GT 300i / Re: Sagging front suspension
« on: September 20, 2023, 05:55:50 PM »
Hello everybody,
Sagging of front fork.
I buy '(may 2021) a second hand Kymco GT300i with 7500 miles. On the road , if small hole or small bump , my front fork was noisy ( knocking) and i reach the the full stroke of the fork ( around 100mm = 4 inches). I put new oil SAE20 but same problem. ( I  know my own weight is around 200lbs !!!).
I took few measurements:
   Free stroke of the fork = 4 inches with spring found in place, ref : 51401-LGE5-E00 ; sagging with bike  own weight = 2 inches ; sagging with me on the bike = 3.2 inches .  So only 0.8 inch left for ridding.

I decide to put 2 stronger springs.
   New spring ( same lengh , same outeside diameter; wire diameter= 11/64 inch), ref ; 51401-LDH1-E00. Sagging with bike  own weight = 0.8 inches ; sagging with me on the bike = 1.5 inches , maximun stroke during heavy braking 3.2 inches.
Road test : no noise , even on holes and bumps. I am happy.
I hope this feedback  will be useful.

3
People GT 300i / Re: WHAT COULD IT BE ....
« on: October 11, 2022, 03:19:39 PM »
I hope you solve the exhaust leakage. just notice that : it is not necessary to remove the exaust pipe. Only the silencer should be  removed. 2 pictures

Pages: [1]