Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - netsurfer802B

Pages: [1]
1
Technical | How To / Kymco Agility 50 Wheel
« on: May 01, 2024, 03:36:16 AM »
I had taken the tire off of a Kymco Agility 50 scooter to have the tire replaced.  After I got it back from shop I installed it in the best I could but there's something wrong. It only turns about/less than 45 degrees each way.  What could be wrong?  More importantly how can I fix it?

2
Agility 50 / Rear Tire Needs to be replaced
« on: May 21, 2023, 08:48:45 PM »
I have a Kymco Agility 50 with a shredded tire that I've been told by the shop that sold it to me that it's tubeless.

I've gotten the big bolt off that holds the tire in place but now the exhaust pipe is in the way.

I really have no idea what tool to use but I'm attaching a picture of what's holding it in place.

Please advise on what exact tool I need to take this off.

It's completely circular and on the inside it looks like an indent in the shape of a star... please click here to see a pic of it ... https://drive.google.com/file/d/1uSW5FrcW7Gr_HNyy3Kn4GRiu1vA1foeU/view?usp=sharing

Thanks in advanced.

3
I order a new carb for about $20.  I'll see what happens when I replace the old one.  It's just not going faster than about 10 miles an hour.  Not really dying on me any more.

4
airfilterbox off, all inducts open, no rodents in?
I hope not.  I didn't see any when I opened up the carb. and sprayed carb. cleaner in it.

I ran the scooter about 5-10 miles an hour after I did that ...when I tried to accelerate all the way it kept making a slow reving up and then down noise but didn't die.  If I had the handle turned to run it at low speed it doen't do this...if this all means anything.

5
Thanks I appreciate it all.

How do I remove the carb?  Are there instructions on how to remove the 2015 Kymco Agility motorscooter carb?  I've looked online to no avail.

Thanks again.

6
I got it used about maybe a few years ago and I THINK the odometer broken so I don't know how many miles it has.

It starts easily now.  It doesn't rev much.

The speedometer is broken so I can't see exactly how fast I'm going but it seems like I can't go over 10 miles an hour.  To me it seems that if I try to put on the gas to go beyond a certain slow point the engine dies every time.

I spoke to a guy that works on scooters and he said that if I turned the key to the on position and I squeeze the brake handle and the break light doesn't come on it's a bad starter solenoid but this is NOT the case because the break light DOES come on.

This has been a pretty good scooter up to this point.   

I'm copying the vehicle registration information from when I bought it about the scoot and pasting it below:

Vehicle Identification Number: LC2U6A026FC001424 Year/Make: 2015 KWANG YANG
MOTOR CO., LTD DBA KYMCO 2 WMI-LC2 RFB
Previous Title State: FLORIDA Registration Expiration Date: 6/21/2023
Title: 120097506 Title Issue Date: 7/25/2019
Title Status: ACTIVE Title Print Date:
Odometer Reading/Status: 9,911 ACTUAL MILEAGE Odometer Date: 6/29/2019
Color: ORANGE Vehicle Type: MOTORCYCLE
BHP/CC: 0/49 Owner Information: 1 owner

7
I have a Kymco 2015 Agility 50 dies when going beyond 5 miles an hour.  I had just replaced the battery in it because it wasn't starting at all but now it dies when I try to go beyond  5 miles an hour.  Is there an idle adjustment I need to make?  Any ideas on how to fix this?

Pages: [1]