Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hanksscooter

Pages: [1]
1
Thanks everyone for your input. I was able to remove the insulation sheathing from the suspected two wires that had been burnt without removing any more screws that were very inaccessible without a special tool to remove the fender skirt. They were burnt within about an inch and a half up to one of the main wiring harnesses. I taped off the ends and all is good now. I was concerned that it might have kept burning further up the line and cause another problem in the electrical system. I guess you could say i got lucky.

Thanks again for your input!

2
Hope some one can tell me how to get the side fairing off completely. I have to access the wiring harness on the right side because I had an short with the bucket light and it started to fry the wires. I need to see how bad it is and where i can replace the wire but first need to get the fairing off.

I took off the rear top cover have the two screws that are holding the side cover in place but it seems to be stuck. I can bend it outward a little but need to be able to remove it completely to access the wiring harness.

Thank you in advance,
Hank

Pages: [1]