Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - scubamick

Pages: [1]
1
MXU / In need of wisdom MXU150
« on: September 03, 2023, 06:26:09 AM »
Hi all,

im struggling with a MXU150 which is causing all kinds of head aches.
its a 2020 bike 9000km from new its had all oils changed regular it had new plug, new fuel filter , new light controller, new gear change switch, new gear controller.
the issue is first it will only start on the kick and sometimes it will not even press down. if the electric starter is used it just turns over, the carb has been cleaned several times and the jets (The idol jet (smallone) had a little blockage but was cleaned out.
second when it runs it can be fine the all of a sudden just cuts out with out warning and then it will not start by either kick or starter, if left for 20 mins or so it sometimes can be kicked started but will take over 10 tries.
any help would be awesome as on a island with out much help..

what has been done i have swooped with a working quad to check the parts ,and they work fine in the other quad , Coil, cdi module, full wire loom taken out inspected and then changed over, battery And charged holding 12.78volts
The only thing was the light module blow a hole in it andand we can only get 45/45 bulbs not 35/35 ok it 20 watts but should not make a difference.

The only difference i can see is that the spark is not as bright and strong  as the working bike but still blue not yellow.
not had chance to check compression as no tester and not had chance to check valve clearance but dont want TO RIP IN to the  ENGINE if i dont have too due to not having much resources on the island.

thanks in advance for any help.
 



 

2
MXU / Mxu 150 stalling in gear
« on: August 04, 2023, 04:21:45 AM »
Hi all thank you for the add,
so my issue is i have a new  mxu 150 it has around 8,000km on the clock. the last trip out it was running fine ( 30min run )
started to head off after a 1hour break and it just died in gear, started again fine, revs in neutral then died after 10meters this happen over and over, checked for lose wires.. that was ok. had to get back home so tried every time it cut out going in to neutral the engine would run, bounce the front break(right hand ) which is quite worn and it would run for 10 to 50 meters.
did this a few times then adjusted the the front break so i could ride with the break lock on managed to get home with out it stalling. question is  where to start to check fro the culprit, gear switch ? each break cut off? but runs fine in neutral....
at a loss so any help is welcome.

the ATV is 1 year old it so far has had the light control switch replaced as it burnt out and it had the gear control unit changed as it was split and had water inside.
the other thing is the ignition key sometimes is difficult to remove and the neutral light and reverse light are both on together when in neutral.

thank you for your time in advance
     

Pages: [1]