Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - KymcoRider2313

Pages: [1]

General Discussion / I need someone to help find me a front fender. K-pipe 125cc

« on: May 31, 2024, 02:32:50 AM »

Hi I'm in real big need of a front fender for the Kymco K-pipe 125cc. cannot find any OEM near me in northern Virginia and all the dealerships don't sell Kymco products anymore. I need something that fits the front so I dont constantly get splashed by bits of water every time I go in the wet roads. 2017 Kymco K-Pipe 125cc

General Discussion / Need help on what to remove and plug off. Vacuum lines

« on: May 18, 2024, 08:00:05 PM »

How do i remove all the vacuum lines and what do i need to do and plug off and take off and keep on. I wanna make the bike simple and have it run without going through an entire system just for gravity to already be doing its job by pulling all the gas from the tank down either way. All this is doing is rerouting air from the engine to push fuel through but it makes the bike feel groggy and slow and it doesn’t even want to idle normal.

General Discussion / Re: Need a front fender but cannot find anywhere.

« on: May 16, 2024, 01:31:16 AM »

Quote from: randyo on May 15, 2024, 08:08:58 PM

how badly damaged, a substantial portion of mine is fabricated from Gorilla tape

i don’t have one which is why i said i needed a replacement

General Discussion / Need a front fender but cannot find anywhere.

« on: May 15, 2024, 07:10:37 PM »

Checked everywhere for a Kymco K-pipe 125cc Front fender replacement no where to be found and cannot use the provided sites on these forums as they do not deliver to Va and or are out of stock.

General Discussion / Do I Need Vacuum Lines On K-Pipe 125cc?

« on: May 12, 2024, 01:11:21 AM »

Hi just wondering I wanted to upgrade my carb on my K-pipe 125cc and wondered do you even need the vacuum lines if gravity is already pulling your fuel down anyway?
I also dont like the huge air filter box and would rather use a coned filter and or something smaller and better so my bike can get more air.

General Discussion / Re: Need Help with kymco k-pipe 125 2017

« on: May 09, 2024, 04:38:23 PM »

Ok thanks guys but the thing is that other forum is about a different topic they talk about the clutch cable adjustments. My issue is more internal feeling and only happens on 1st and 2nd gear where the bike jerks and feels like it slips at around 4000-5000 rpm

General Discussion / Need Help with kymco k-pipe 125 2017

« on: May 09, 2024, 05:35:06 AM »

Ok so I'm having an issue with my kymco k-pipe 125cc. I haven't really modded anything much on the engine side of it besides an exhaust but I'm having issues where I feel the bike jerk and feels like it slips when im already engaged on the clutch and im going up in speed. I'm like mid 5000 RPM and the bike jerks this is like 3-5 seconds after letting go of the clutch and throttling up. I'm suspecting maybe the clutch is going out but I wanted to make sure first before going out and replacing parts I prob dont need to replace. Also on top of that I legit cannot find a single place or website that sells kymco clutch assembly's. I tried searching everywhere for the last hour or 2 for one and only one I can find is a used clutch from france and the dudes charging $90 for shipping and on top of that the $50 for the clutch. its stupid to go through all that for a used clutch. Please help me.