Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - manny

Pages: [1]
1
Technical | How To / Re: Kymco 50 Filly no electric current when key turned :(
« on: May 25, 2011, 07:02:10 AM »
OK so I ended up taking all the plastics off to see if there was any wire pinched, did not see anything.  So I checked every electrical connection possible.  From making sure to having new fuses, to making sure power was going to igntion coil, switch, key.  Somehow when I pulled the plastics off the horn, signals, started working, also when key was turned to on, the switch turned on.  Weird, so I checked around the speedometer and around the forks to make sure nothing was pinching.  Put the plastics back on, turned the key to on, and used my motorcycle starter solenoid to start the bike, which I have to disconnect it so the starter doesnt stay on.  One of my fuses blew out so my lights and horn stop working.  I tested my starter relay and its out.  Is there a place I can get these local?  I took it to advance auto and got one identical part#3137 , but returned it cause I was still having problems.  Can anyone verify if that relay would work? Where would I be able to get one local?  I am planning on taking all the black tape off the wiring and inspect each one  :'( Keep everyone posted

2
Technical | How To / Re: Kymco 50 Filly no electric current when key turned :(
« on: May 23, 2011, 05:08:22 PM »
Hi and thanks for your response, new battery 12.8, both fuses good, is there any other besides the ones around the battery?  I checked where the push start button is and there is no current to the switch. No horn, no lights no blinkers, with key in on position and kill switch is on ???

3
Technical | How To / Re: fuse blowing
« on: May 23, 2011, 05:12:23 AM »
where is the ignition switch relay??? Maybe thats the problem with mine :(

4
Technical | How To / Kymco 50 Filly no electric current when key turned :(
« on: May 23, 2011, 04:56:37 AM »
Hi everyone, I am having problems with my 2003 50 filly.  I have been working on narrowing down the problem, and I figured it was the relay switch, since I would start it with a motorcycle starter solenoid.  Now I turn the key and no current is passing through, the horn doesn work or blinkers nothing, so the scooter doesnt start.  I just bought a new battery and I was turning it on with the solenoid, (anyone know where I can get a stater relay for it?) now I cant even turn it on, cause when I turn the key, no current.  I was messing with the left handle bar/break switch was getting stuck, so I sprayed a little of wd 40 so it would not stick.  After that it didnt work.  There were no wires there, just a little black plasting that when break is pulled it sticks out.  Anyone have any idea what this could be or and also how can I check the relay? thanks and hope someone can help whos had this problem....

Pages: [1]