Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Prostidude

Pages: [1]
1
Agility 125 / Re: Agility 16+ noise identification
« on: September 08, 2024, 09:49:54 PM »
hey guys, thanks for the reply. i havent checked exhaust gasket as i dont think there should be difference between no-load and load, i thought if it was gasket it could be heard when on center stand...for the unusual sound at 53 and 59sec, its probably toolbox as i carry one under seat so i probably rode over small bump and it rattled little bit :-) i was thinking maybe it has something to do with PAIR system? from what i've read it should dump some fresh air into exhaust to burn excess fuel that leaves cylinder unburnt-this might explain why i hear something similar to spark knock? and it would probably resonate thru head back into valve cover part resulting in echo ? it is weird it is always there, only after half throttle and only under load... i am running out of ideas however i will visit kymco authorized repairguy in my hometown to let him listen to this, he has years of experience with kymcos so he might be able to help without actually taking apart half of the engine hehe, will post what i find
and to the valve clearance, i used 0.1 feeler gauge however, its very loose on both valves(still cant stick in 0.15) so we are somewhere between 0.1-0.13+- and as there are no start/performance troubles and tapping i guess its all fine =)

2
Agility 125 / Agility 16+ noise identification
« on: September 07, 2024, 08:49:58 PM »
Hello, I’ve bought this scooter with 9k km on tacho and I am trying to find source of weird sound-symptoms below Non-metallic rattling sound above 50% of the throttle Only under load Sound is similar to spark knock, doesn’t change with high/low octane fuel-stock cdi from factory Seems to be coming from top end of the engine Valve clearances are tight 0.1mm on intake and loose 0.1mm on exhaust No power loss or any issues with acceleration/performance - starts and idle nicely Previous owner mentioned valve lifters-may this be the cause ? Tried to capture sound however my iPhone ignored this frequency for some reason and I will try to do it with other phones so I can post it here… Inspected clutch and variator, rollers are like new, replaced belt as it was worn, cleaned dust and re-finished clutch and bell with sandpaper as it was slipping, new variator guides as there was quite lot of sideways movement, crankshaft has no play by hand/at high rpm on center stand so i assume it’s not cvt related Any input will be helpful


here is audio where you can hear that sound whenever i WOT http://sndup.net/9h8k7

Pages: [1]