Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - shibahiro976

Pages: [1]
1
Agility 125 / Re: Agility 16+ noise identification
« on: October 02, 2024, 06:15:55 PM »
Simply take off tupperware (seat off, METIN box out) and have a look where it belongs to.

I cannot check it before Sunday. I was hoping for someone with a similar problem before I disassemble

2
Agility 125 / Re: Agility 16+ noise identification
« on: October 02, 2024, 06:28:41 AM »


No. That looks like the end of the 'puke tube' - a tube which drains the airbox.

unfortunately it is not the tube wich drains the airbox (see pic!)
this tube comes from the bottom! It arrives in the head cover area.
Could someone check the area and take some photos for comparison, please?
thanks for your time!

3
Agility 125 / Re: Agility 16+ noise identification
« on: October 01, 2024, 10:31:07 AM »


hello everyone!
yesterday i noticed that i have a small tube on my agility, disconnected!
Could this be the cause of the noise?
one of these days, i'll try to open it and check!
Do you have this little tube? What should it be attached to? It has a locking clip!

4
Agility 125 / Re: Agility 16+ noise identification
« on: September 21, 2024, 09:50:29 AM »
hey guys, thanks for the reply. i havent checked exhaust gasket as i dont think there should be difference between no-load and load, i thought if it was gasket it could be heard when on center stand...for the unusual sound at 53 and 59sec, its probably toolbox as i carry one under seat so i probably rode over small bump and it rattled little bit :-) i was thinking maybe it has something to do with PAIR system? from what i've read it should dump some fresh air into exhaust to burn excess fuel that leaves cylinder unburnt-this might explain why i hear something similar to spark knock? and it would probably resonate thru head back into valve cover part resulting in echo ? it is weird it is always there, only after half throttle and only under load... i am running out of ideas however i will visit kymco authorized repairguy in my hometown to let him listen to this, he has years of experience with kymcos so he might be able to help without actually taking apart half of the engine hehe, will post what i find
and to the valve clearance, i used 0.1 feeler gauge however, its very loose on both valves(still cant stick in 0.15) so we are somewhere between 0.1-0.13+- and as there are no start/performance troubles and tapping i guess its all fine =)

news?
Thank you!

5
Agility 125 / Re: Agility 16+ noise identification
« on: September 14, 2024, 11:37:59 AM »
here, in my town, no kymco's mechanic has solved the problem! Everything is ok, in their opinion I'm waiting for a reply from Prostidude, he could help me out too!
Incidentally, it is the only one I have found on the entire planet with the same noise as my scooter!  ;D

6
Agility 125 / Re: Agility 16+ noise identification
« on: September 13, 2024, 04:09:03 PM »
I have a Kymco Agility R16+ (2021), I have the same problem and noise. All Identical!
On my scooter I have checked and tightened all visible bolts (kickstand, body, etc), replaced the variator (whit malossi), belt, clutch and bell! The noise is still there! I don't hear it when it's on the stand, stationary! (at least I think so). I was thinking a problem with the exhaust, manifold area (gasket/bolts) or internal (some internal broken part!).
When we are sitting on the scooter our weight probably affects the position of the exhaust.(???)
The scooter is perfect in performance. Just this noise on acceleration. I follow this discussion. You are the only one with the exact same problem as me!
I was looking for information on this and found this post!

I forgot... I have already change motor oil, trasmission oil and spark plug!


Pages: [1]