Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dragracer

Pages: [1]
1
LIKE 200i / Re: New to me Like 200i.
« on: November 11, 2024, 06:14:22 PM »
I bought it not running. It's wouldn't start with the old pump. As I stated the old pump had 20psi, and the new one 35psi, which is still lower than what I read on this site. The injector has a crappy spray pattern, so I am replacing it. Bought a new one, and just haven't gotten it in yet.



Curious here.
How was your LIKE running with the original fuel pump, before you replaced it?
Same as now, or??
Stig

2
LIKE 200i / Re: New to me Like 200i.
« on: November 06, 2024, 05:27:35 PM »
I'm using a plain $10 code reader with this cable: https://www.amazon.com/dp/B091YHDKP6?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

It went thru the same procedure as when reading my car, so I'm assuming it's working.

3
LIKE 200i / Re: New to me Like 200i.
« on: November 04, 2024, 09:37:26 PM »
Thanks for the response, Ruffus. I will do both, and see if anything changes. Mt check engine light doesn't appear to work, as it doesn't come on with the key.

4
LIKE 200i / New to me Like 200i.
« on: November 04, 2024, 01:47:24 PM »
I'm a new owner of a used Like 200i, and it has some problems. I found the fuel pressure spec here, bar 3 bar (45psi). My original pump was putting out 20psi. I replaced it with a Kemso pump from Amazon. My fuel pressure now shows 35psi, and it now starts and runs. It has a rough idle, and a surge when trying to ride the scooter. There are no detectable vacuum leaks.

My dash check engine light doesn't come on, and the clock is inop. No display. I purchased a cable to adapt my OBDII code reader to this scooter, and the code reader show no codes.

The scooter is in decent shape for it's age. The plastics are all good. I'd like to restore it, and keep it. Any advice is welcomed. I'm in Lecanto, Fl. about 1 hour north of Tampa.

Pages: [1]