Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 50mxer_Des

Pages: [1]
1
MXU / Re: 50 mxer carb setup
« on: June 16, 2011, 03:48:05 PM »
Hi Pete,

Thanks - Great minds think alike!

Just done that and for future ref by other 50Mxer's it's:

1. "Air Mix Screw" (fwd most screw) screw in fully (don't over tighten) then out 2 turns.

2. Adjust idle speed with "Throttle Stop Screw" (other screw)

3. Adjust Air Mix Screw for max revs.

Sure I'll have other questions but for now, it's Ciao!

Des

2
MXU / 50 mxer carb setup
« on: June 16, 2011, 02:11:03 PM »
Hi All,

I'm new here and hope someone can point me in the right direction!

We have bought our son an old 50 mxer and I need some help setting the carb up properly.

The carb is a Keihin "KT" with auto choke. There are two adjuster screws on the left-hand side of the carb body which I'm guessing are the mixture and tickover settings.

Is there a "standard" setting for these i.e. "screw in fully then back off 3 turns" ...

We're having a real headache getting it to run properly and I want to get everything back to "factory" before trying anything else!

If there's some info that would help, just shout  :)

Thanks to all,

Des

Pages: [1]